This study reports on the ultralubricity of a high-temperature resilient nanocomposite WS2/a-C tribocoating. The coefficient of friction of this coating remains at around 0.02 independently of a thermal treatment up to ∼500 °C, as confirmed by high-temperature tribotests. Moreover, the coating annealed at 450 °C keeps exhibiting a similar ultralubricity when cooled back down to room temperature and tested there, implying a tribological self-adaptation over a broad temperature range. High-resolution TEM observations of the tribofilms on the wear track unveil that WS2 nanoplatelets form dynamically via atomic rearrangement and extend via unfaulting geometrical defects (bound by partial climb dislocations). The (002) basal planes of the WS2 nanoplatelets, reoriented parallel to the tribo-sliding direction, contribute to a sustainable ultralubricity. The declining triboperformance beyond 500 °C is associated with sulfur loss rather than the transformation of WS2 into inferior WO3 via oxidation as suggested earlier. This self-adaptive WS2/a-C tribocoating holds promise for a constant ultralubrication with excellent thermal performance.
Carbon-doped titanium oxide (C/Ti-O) films were prepared on Si(100) wafer, stainless steel (type 304) and glass by reactive magnetron sputtering (RMS) using CO2 gas as carbon and oxygen source under room temperature (RT). X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) were used to analyze structure and composition of the as-prepared C/Ti-O film. It could be observed from XRD that the as-prepared C/Ti-O film contained TiO crystal phase structure. Ti2p XPS spectrum of the as-prepared C/Ti-O film showed that the valences of titanium were made up of Ti2+, Ti3+ and Ti4+. C1s XPS spectrum revealed that carbon was doped into titanium oxide based on the existence of the typical Ti-C bond. The optical absorption curve by ultraviolet-visible (UV-Vis) spectrophotometer showed that the C/Ti-O film appeared the remarkable red shift of absorption edge, which contributed to C substitution in O sites in amorphous TiO2. Photocatalysis test using methyl orange (MO) as indicator confirmed that the as-prepared C/Ti-O film had photocatalytic activity. Combined with the results of the tests and first-principles calculations, a potential photocatalysis mechanism was proposed.