A new design of the boron-lined gaseous neutron detector composed of a boron-lined honeycomb neutron converter and an electron multiplier is proposed in this paper. The motivation for this research was to decrease the manufacturing difficulty and improve the robustness of the boron-lined gaseous neutron detector. The numerous anode wires in the traditional designs were removed, and the gas electron multiplier (GEM) was used as the electron multiplier. To drive the ionized electrons produced inside the honeycomb structure out to the incident surface of the GEM, a drift electric field was applied inside the holes of the honeycomb structure. The design principles of this detector were discussed. Geant4, Maxwell11, and Garfield9 were used to estimate the neutron absorption efficiency and the electron migration process. A prototype detector was constructed and experimentally evaluated. Both the simulation and experimental results indicate that this detector has the potential to be used in the applications of small angle neutron scattering for scientific research, and to replace the currently used 3 He detectors, which have the trouble of very limited supply of 3 He gas.
Both X-ray imaging and neutron imaging are essential methods in non-destructive testing. In this work, a bimodal imaging method combining neutron and X-ray imaging is introduced. The experiment is based on a small electron accelerator-based photoneutron source that can simultaneously generate the following two kinds of radiations: X-ray and neutron. This identification method utilizes the attenuation difference of the two rays’ incidence on the same material to determine the material’s properties based on dual-imaging fusion. It can enhance the identification of the materials from single ray imaging and has the potential for widespread use in on-site, non-destructive testing where metallic materials and non-metallic materials are mixed.
A variety of boron coating methods have been applied for realizing the boron-lined gaseous neutron detectors, however they usually have to face the problem of non-uniform thickness for large area boron coating and low utilization ratio of boron materials. In this study, a Boron Nano Particle (BNP)-based drip-coating method was researched and introduced, with the advantages of fast boron coating speed and high utilization ratio of boron material. Neutron tests conducted at the Institute Laue Langevin, Grenoble, France, demonstrated that the natB4C sample made by this method can realize boron layer with the mass thickness ranging from 0.05 to 0.5 mg/cm2, as well as a good thickness uniformity, indicating that the BNP-based drip-coating method has the potential to realize boron layers that can be used for various boron-lined gaseous neutron detectors.