Aleksandar Jovic

Mr. Aleksandar Jovic

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 January 2019 in IEEE Transactions on Power Delivery
Verified
Journal Article
Closed access
LKLidija M. Korunović
Lidija M. Korunović
AJAleksandar Jovic
Aleksandar Jovic
SDSasa Djokic
Sasa Djokic
This paper analyzes the effects of shunt capacitors installed on the low voltage sides of 10/0.4 kV distribution transformers on the operation of these transformers. Using the results of an extensive measurement campaign, this paper compares: real and reactive power losses, secondary-side current, and primary-side apparent power before and after the installation of transformer capacitors. The following four cases of reactive power compensation are considered and discussed: adequate, conditionally adequate, and total compensation, as well as overcompensation. The presented analysis helps to identify transformer substations where the initial compensation should be changed or adjusted, in order to improve transformers' operational performance. Voltage dependencies of real and reactive power demands of the transformer-supplied loads are taken into account, based on the previously identified load characteristics in the considered networks as well as voltage dependence of reactive power of shunt capacitors. The result with and without including these voltage dependencies in the analysis is compared and discussed.

10 August 2021 in Energies
Verified
Journal Article
Open access
PDF file
AJAleksandar Jovic
Aleksandar Jovic
LKLidija M. Korunović
Lidija M. Korunović
SDSasa Djokic
Sasa Djokic
This paper presents a novel approach for estimating the parameters of the most frequently used static load model, which is based on the use of meteorological variables and is an alternative to the commonly used but time-consuming measurement-based approach. The presented model employs five frequently reported meteorological variables (ambient temperature, relative humidity, atmospheric pressure, wind speed, and wind direction) and the load model parameters as the independent and dependent variables, respectively. The analysis compared the load model parameters obtained by using all five meteorological variables and also when the meteorological variables with the lowest influence are omitted successively (one by one) from the model. It is recommended based on these results to use the model with the maximum accuracy, i.e., with five meteorological variables. The model was validated on a validation set of measurements, demonstrating its applicability for the estimation of load model parameters when the measurements of electrical variables for parameter identification are not available. Finally, load model parameters of the analyzed demand were estimated on the basis of only ambient temperature, and it was found that such a linear model can be used with a similar accuracy as the models with up to four meteorological variables.