Volumetric strain changes associated with the October 2013 M w 6.2 Ruisui earthquake were recorded by a network made up with four borehole Sacks-Evertson dilatometers in eastern Taiwan. These instruments are located within 25–30 km of the seismic source providing also high-resolution near-field observations. Co-seismic offsets larger than a few 10 2 n ε were seen by most of the sensors. We relocated the 30 km × 30 km fault plane through a grid-search approach. The inferred fault parameters (217°, 48°, 49°) are in reasonable agreement with those resulting from the inversions of long-period seismic waves (209°, 59°, 50°) as well as from GPS data inversion (200°, 45°, 42°). Moreover, analysis of the 100-Hz sampling data 10 s before seismic radiations indicate no pre-seismic strain change emergent from the instrumental noise level (from 10 −2 to 10 −1 n ε). Such an observation sets limits on any precursory change in a nucleation area, taken to have dimensions of about 250–300 m, seconds before the mainshock. Thus, the upper limit of any pre-seismic moment is about 10 −5 % of the total seismic moment of the Ruisui earthquake.
Geodetic instruments now offer compelling sensitivity, allowing to investigate how solid Earth and surface processes interact. By combining surface air pressure data, nontidal sea level variations model, and rainfall data, we systematically analyze the volumetric deformation of the shallow crust at seven borehole strainmeters in Taiwan induced by 31 tropical cyclones (typhoons) that made landfall to the island from 2004 to 2013. The typhoon's signature consists in a ground dilatation due to air pressure drop, generally followed by a larger ground compression. We show that this compression phase can be mostly explained by the mass loading of rainwater that falls on the ground and concentrates in the valleys towards the strainmeter sensitivity zone. Further, our analysis shows that borehole strainmeters can help quantifying the amount of rainwater accumulating and flowing over a watershed during heavy rainfalls, which is a useful constraint for building hydrological models.
As one of the most sensitive instruments for deformation monitoring in geophysics, borehole strainmeter has the capability to record a large spectrum of tectonic and environmental signals. Sensors are usually deployed near active faults and volcanoes and provide high-resolution continuous recordings of seismic and aseismic signals, hydrological variations (rainfall, groundwater level) and natural hazards (tropical cyclones, landslides, tsunamis). On the occasion of the 50th anniversary of the installation of the first Sacks–Evertson borehole strainmeter, in central Japan, we present an overview of the major scientific contributions and advances enabled by borehole strainmeter measurements in Taiwan since their installation in the mid 2000s. We also propose a set of future research directions that address recent challenges in seismology, hydrology and crustal strain modeling.