The performance of superconducting radiofrequency (SRF) cavities used for particle accelerators depends on two characteristic material parameters: field of first flux entry and pinning strength. The former sets the limit for the maximum achievable accelerating gradient, while the latter determines how efficiently flux can be expelled related to the maximum achievable quality factor. In this paper, a method based on muon spin rotation () is developed to probe these parameters on samples. It combines measurements from two different spectrometers, one being specifically built for these studies and samples of different geometries. It is found that annealing at virtually eliminates all pinning. Such an annealed substrate is ideally suited to measure of layered superconductors, which might enable accelerating gradients beyond bulk niobium technology.
20 March 2019 in Superconductor Science and Technology
Nb3Sn is currently the most promising material other than niobium for future superconducting radiofrequency cavities. Critical fields above 120 mT in pulsed operation and about 80 mT in CW have been achieved in cavity tests. This is large compared to the lower critical field as derived from the London penetration depth, extracted from low field surface impedance measurements. In this paper direct measurements of the London penetration depth from which the lower critical field and the superheating field are derived are presented. The field of first vortex penetration is measured under DC and RF fields. The combined results confirm that Nb3Sn cavities are indeed operated in a metastable state above the lower critical field but are currently limited to a critical field well below the superheating field.
We report depth-resolved measurements of the Meissner screening profile in several surface-treated samples using low-energy muon spin rotation. In these experiments, implanted positive muons, whose stopping depths below ’s surface are adjusted between approximately and , reveal the field distribution inside the superconducting element via their spin precession (communicated through their radioactive decay products). We compare how the field screening is modified by different surface treatments commonly used to prepare superconducting radio-frequency cavities used in accelerator beamlines. In contrast to an earlier report [A. Romanenko et al., Appl. Phys. Lett. 104, 072601 (2014)], we find no evidence for any “anomalous” modifications to the Meissner profiles, with all data being well described by a London model. Differences in screening properties between surface treatments can be explained by changes to the carrier mean free paths resulting from dopant profiles near the material’s surface.
7 November 2017 in Superconductor Science and Technology
Using muon spin rotation it is shown that the field of first flux penetration in Nb is enhanced by about 30% if coated with an overlayer of Nb 3 Sn or MgB 2 . This is consistent with an increase from the lower critical magnetic field up to the superheating field of the Nb substrate. In the experiments presented here coatings of Nb 3 Sn and MgB 2 with a thickness between 50 and 2000 nm have been tested. does not depend on material or thickness. This suggests that the energy barrier at the boundary between the two materials prevents flux entry up to of the substrate. A mechanism consistent with these findings is that the proximity effect recovers the stability of the energy barrier for flux penetration, which is suppressed by defects for uncoated samples. Additionally, a low temperature baked Nb sample has been tested. Here a 6% increase of was found, also pushing beyond .
superconducting radio-frequency (SRF) cavities are observed to break down and lose their high- superconducting properties at accelerating gradients below the limits imposed by theory. The microscopic origins of SRF cavity breakdown are still a matter of some debate. To investigate these microscopic issues, temperature- and power-dependent local third-harmonic response is measured on bulk and thin-film samples using a novel near-field magnetic microwave microscope between 2.9 and 10 K and 2 and 6 GHz. Both periodic and nonperiodic response as a function of applied rf field amplitude are observed. We attribute these features to extrinsic and intrinsic nonlinear responses of the sample. The rf-current-biased resistively shunted junction (RSJ) model can account for the periodic response and fits very well to the data using reasonable parameters. The nonperiodic response is consistent with vortex semiloops penetrating into the bulk of the sample once sufficiently high rf magnetic field is applied and the data can be fit to a time-dependent Ginzburg-Landau (TDGL) model of this process. The fact that these responses are measured on a wide variety of samples suggests that we are capturing the generic nonlinear response of air-exposed surfaces.
7 November 2017 in Superconductor Science and Technology
Point contact tunneling and low energy muon spin rotation are used to probe, on the same samples, the surface superconducting properties of micrometer thick niobium films deposited onto copper substrates using different sputtering techniques: diode, dc magnetron and HIPIMS. The combined results are compared to radio-frequency tests performances of RF cavities made with the same processes. Degraded surface superconducting properties are found to correlate to lower quality factors and stronger Q-slope. In addition, both techniques find evidence for surface paramagnetism on all samples and particularly on Nb films prepared by HIPIMS.