A field test was performed to study the response of an 800 mm internal diameter, hybrid (plastic/metal) structured wall pipe during installation and varied traffic loading. Synchronized measurements were made of radial soil pressures adjacent to the pipe and pipe deflection, allowing representation of the pressure–deflection relationship of the soil–pipe system. Soil pressures were measured using null pressure measurement cells that avoid the effects of membrane deflection, soil stiffness, and stress history. It is concluded that the critical point in the lifetime of a flexible, shallow buried pipe is when the trench has been backfilled and compacted to the subgrade surface. At this point, the final pavement/asphalt layers have yet to be installed, yet very large loads may be traversing above the pipe section. Once the final pavement layers are constructed, the pressures reaching the pipe crown will become smaller, as will the respective deflections. As a result of the simultaneous and continuous measurement of soil pressure adjacent to the pipe and pipe deflections during the field test, a scheme has been suggested for approximate prediction of flexible pipe deflection in response to traffic loading.
1 July 2025 in Journal of Geotechnical and Geoenvironmental Engineering
The simple shear test has been an important tool in practical geotechnical engineering and the study of soil behaviour. The attractiveness of the simple shear test is founded in its relative ease of specimen preparation, similarity to at-rest conditions during consolidation and rotation of principal stresses during shear. Despite this test's attractive qualities, there are significant deficiencies in the interpretation of standard test results: horizontal normal stresses are not known and excess pore pressures are often interpreted from assumptions about constant-volume tests without saturation. To address this problem, a set of monotonic tests were performed on a sand, during which horizontal normal stresses were measured in the central portion of specimens. Based on the measurements, the full state of stress was defined, stress paths were drawn and directions of the principal stresses were determined. Outcomes showed that the conventional approach of estimating excess pore pressures as the change in vertical pressure to maintain constant volume in response to shear is problematic, and friction angles interpreted from conventionally measured shear and vertical stresses may be grossly underestimated in some cases.
This article describes the development of sensing tools designed and applied to the direct measurement of shear stresses and shear strain within a soil mass. The importance in the development of these tools is in their ability to measure shear stresses and shear distortions within soil without any a priori information of the stress and strains applied at the boundaries of the system. These tools may be applied to element testing, testing of physical models, and field applications. The sensors were used in the testing of a sand in a large simple shear apparatus, under both constant height and constant vertical pressure conditions. Testing demonstrated that shear stresses smaller than 0.1 kPa are easily resolved. Shear strains smaller than 10−5 (abs) were reliably measured. Measurement of shear stress and shear distortion within the soil mass allows for direct determination of the shear stiffness of the soil. Shear stiffness measured in this fashion is significantly greater than that determined from the globally measured shear stress and shear strain. The stiffness degradation curve illustrates a constant shear stiffness over the range of 10−5 through 5·10−4.
12 June 2022 in Geotechnical and Geological Engineering
The paper deals with three issues relevant to the application of TDR methods for monitoring water content in compacted clay soils: ( i) the dependence on dry density, ( ii) the ability to monitor changes in water content in clay soil approaching saturation, and ( iii) difficulties in performing efficient and reliable calibrations. A calibration scheme which inherently controls dry density of the specimen has been developed and applied. The methodology creates continuous calibration curves over a range of volumetric water content from a single test specimen. The new approach has been applied in monitoring the advance of a wetting front through a compacted swelling clay in a laboratory environment.