Precise localization has attracted considerable interest in Wireless Sensor Networks (WSNs) localization systems. Due to the internal or external disturbance, the existence of the outliers, including both the distance outliers and the anchor outliers, severely decreases the localization accuracy. In order to eliminate both kinds of outliers simultaneously, an outlier detection method is proposed based on the maximum entropy principle and fuzzy set theory. Since not all the outliers can be detected in the detection process, the Maximum Entropy Function (MEF) method is utilized to tolerate the errors and calculate the optimal estimated locations of unknown nodes. Simulation results demonstrate that the proposed localization method remains stable while the outliers vary. Moreover, the localization accuracy is highly improved by wisely rejecting outliers.
Ion milling, wedge cutting or polishing, and focused ion beam (FIB) milling are widely-used techniques for the transmission electron microscope (TEM) sample preparation. Especially, the FIB milling provides a site-specific analysis, deposition, and ablation of materials in the micrometer and nanometer scale. However, the cost of FIB tools has been always a significant concern. Since it is inevitable to use the FIB technique, the improvement of efficiency is a key point. Traditional TEM sample preparation with FIB was routinely implemented on a single sample each time. Aiming at cost efficiency, a new pre-thinning technique for batch sample preparation was developed in this paper. The present proposal combines the sample preparation techniques with multi-samples thinning, cross-section scanning electron microscopy (SEM), wedge cutting, FIB and other sample pre-thinning techniques. The new pre-thinning technique is to prepare an edge TEM sample on a grinding and polishing fixture with a slant surface. The thickness of the wedges sample can be measured to 1∼2 μm under optical microscope. Therefore, this fixture is superior to the traditional optical method of estimating the membrane thickness. Moreover, by utilizing a multi-sample holding fixture, more samples can be pre-thinned simultaneously, which significantly improved the productivity of TEM sample preparation.
The intrinsic parameter of multifunction integrated optic chip is extracted and found to be linear with wavelength and temperature experimentally. The scale factor stability of FOG is improved by about ten times with the established model.