Resumo As mudanças climáticas no século XXI é uma realidade inconteste. Diversos efeitos e impactos vêm sendo registrados em várias regiões do planeta. Este trabalho tem por objetivo avaliar a associação do modelo hidrológico MHD-INPE ao modelo atmosférico Eta/CPTEC, a fim de simular o impacto de mudanças climáticas na Bacia Hidrográfica do Ribeirão Jaguara, localizada no sul do estado de Minas Gerais. Para tal fim, foram utilizados dois cenários (RCP4.5 e RCP8.5) de três modelos globais (HadGEM2-ES, MIROC5 e CanESM2), regionalizados pelo modelo Eta. Os resultados da calibração e validação mostraram uma boa performance MHD-INPE em simular a vazão da BHRJ. Após a correção de viés, as saídas dos cenários foram usadas como entrada no MHD-INPE. As projeções climáticas corrigidas dos cenários resultaram em predominante redução da precipitação ao longo do século. Os resultados das projeções da temperatura mostraram aumento consensual por parte dos modelos climáticos, em ambos os cenários. As estatísticas da curva de permanência das vazões advindas das simulações climáticas mostraram um bom desempenho do MHD-INPE na simulação do clima presente.
1 March 2022 in Journal of South American Earth Sciences
Runoff projections are subject to uncertainties related to model structure and parameters. This study aims to analyze uncertainties in long-term runoff estimations from an empirical (Budyko framework) and a conceptual hydrological model (MHD-INPE). Results indicate that both MHD-INPE and Budyko estimations tend to overestimate long-term runoff during years of recurring droughts. Pareto front solutions in MHD-INPE exhibited small uncertainties in long-term runoff estimations regarding parameter calibration (bias between 5 and 7%); differences were observed in low (bellow 5% variation) and high (bellow 10% variation) daily runoff. Related to model structure uncertainties, both models follow similar patterns and performance for a qualitative analysis. Budyko's future projections tend to exceed MHD-INPE's during high precipitation estimates, where at 2000 mm yearly precipitation the estimated runoff from Budyko tends to be 100 mm greater than the hydrological model. Under arid conditions Budyko tends to estimate smaller runoff than MHD-INPE due to variations in soil moisture and water storage not properly represented in Budyko's parameter. Although uncertainties were identified related to model complexity and calibrated parameters, higher uncertainties were identified as related to the climate models. Therefore, the Budyko method is a viable alternative for first-order analysis of long-term impacts.
Landform classification is important for representing soil physical properties varying continuously across the landscape and for understanding many hydrological processes in watersheds. Considering it, this study aims to use a geomorphology map (Geomorphons) as an input to a physically based hydrological model (Distributed Hydrology Soil Vegetation Model (DHSVM)) in a mountainous headwater watershed. A sensitivity analysis of five soil parameters was evaluated for streamflow simulation in each Geomorphons feature. As infiltration and saturation excess overland flow are important mechanisms for streamflow generation in complex terrain watersheds, the model’s input soil parameters were most sensitive in the “slope”, “hollow”, and “valley” features. Thus, the simulated streamflow was compared with observed data for calibration and validation. The model performance was satisfactory and equivalent to previous simulations in the same watershed using pedological survey and moisture zone maps. Therefore, the results from this study indicate that a geomorphologically based map is applicable and representative for spatially distributing hydrological parameters in the DHSVM.
1 January 2023 in Engenharia Sanitaria e Ambiental
Rainfall simulators are an important tool in many areas of geosciences. The authors of most of the studies published with rainfall simulators try to get the most uniform distribution of precipitation as possible. However, since this is very difficult, indexes are used to assess the greater or lesser uniformity of precipitation in the plot area under study. One of the most used indexes is the Christiansen uniformity coefficient. In this work, changes in the geometry of the wetted area of the plot were analyzed to improve the uniformity of precipitation. This was evaluated through the intensity of precipitation and Christiansen uniformity coefficient in the wet area. The tests were carried out using two models of spray nozzles and different operating pressures. The initial plot geometry was 0.7 x 1.0 m (0.7 m2). The Christiansen uniformity coefficient results were classified as low, while the best performance in terms of precipitation uniformity was obtained at a pressure of 48.3 kPa. Non-uniform precipitation was observable near the outer limits of the plot. Based on the best Christiansen uniformity coefficient results, it was proposed to reduce the effective area of the experimental plot from 0.70 to 0.56 m2, leading to a precipitation intensity of 114.07 and 149.20 mm·h−1, and a Christiansen uniformity coefficient of 81.6 and 83.8%, with the two models of spray nozzles. The results showed that adjusting the geometry of the plot can lead, in a simple and fast way, to a better uniformity of artificial rainfall.