A 6-bit full-span programmable vector-sum phase shifter was presented in this brief. A transformer-based matching network is used to match the PPF-based I/Q generator to the variable gain amplifier-based vector-modulator (VGA-based VM), which eliminates the performance degradation due to impedance mismatch. The proposed phase shifter integrated in a two-channel transmitter was implemented in a 180-nm CMOS process. A program-assisted method was used to select the desired 6-bit (64) phase states from the total 4096 measured states of the chip, to realize a highly accurate phase tuning. The center frequency of the phase tuning can be set in the program, for different operation frequency points. An ultra-low root-mean-square (rms) phase/gain error less than 0.5°/0.15 dB are obtained at corresponding single frequency points. Moreover, a “band” mode is available as well, and rms phase/gain errors less than 2.25°/0.56 dB and 1.1°/0.32 dB are obtained at 4–10 GHz and 5.5-7.5 GHz, respectively.
Light-trapping nanostructures have been widely used for improving solar cells’ performance, but the higher surface recombination and poor electrode contact introduced need to be addressed. In this work, silicon nanostructures were synthesized via silver-catalyzed etching to texturize solar cells. Atomic-layer-deposited Al2O3 passivated the nanotextured cells. A surface recombination velocity of 126 cm/s was obtained, much lower than the 228 cm/s of the SiNX-passivated one. Additionally, the open-circuit voltage (VOC) of the nanotextured cells improved significantly from 582 to 610 mV, as did the short-circuit current (JSC) from 25.5 to 31 mA/cm2. Furthermore, the electrode contact property was enhanced by light-induced plating. A best efficiency of 13.3% for nano-textured cells was obtained, which is higher than the planar cell’s 12%.
6 April 2022 in Microwave and Optical Technology Letters
CMOS power amplifier (PA) has advantages in power consumption and integration, while the lower operating voltage limits its output power. An area efficient power combiner needs to be designed to improve the output power of CMOS PA. An X-band integrated PA using 65-nm CMOS bulk technology was presented in this work. The whole PA consists of two differential stages: a one-way drive amplifier and a two-way main amplifier. By employing a compactly designed high-k output transformer, the CMOS PA occupied a small core-area of 0.47×0.57mm2, and delivered 21.6 dBm of measured saturated output power with 23.6% of power-added efficiency at 10 GHz from a 1.2-V power supply. Simultaneously, this PA can operate well in 8∼15 GHz wideband.
29 April 2026 in Circuits, Systems, and Signal Processing