The article is devoted to the study of the influence of residual sulfuric and phosphoric acids on the process of processing large-tonnage phosphogypsum (PG) waste into calcium carbonate. In the Russian Federation, about 10 percent of existing phosphogypsum waste is processed into construction materials. Acidic impurities (phosphoric and sulfuric acids) in their composition are an obstacle to the use of phosphogypsum for the production of binders. This study finds that impurities also reduce the chemical activity of phosphogypsum. At the same time, the paper focuses on the potential of phosphogypsum for the production of calcium carbonate. This article investigated the amount of impurities in phosphogypsum. The results show that during automatic washing of phosphogypsum, losses are approximately 30–35 wt. %. It was also found that phosphogypsum by 22% consists of impurities of phosphoric and sulfuric acid. These acids are characteristic waste products of extraction phosphoric acid (EPA) production. By ASTM C471M-20ae1, the content of calcium sulfate dehydrate and hemihydrate before and after washing was determined. A thermodynamic calculation of the proposed interaction of phosphogypsum with carbonates showed that the characteristic reaction is possible. The conversion process of phosphogypsum to get the corresponding calcium carbonate was carried out at 70 °C. Data on the chemical composition of the reaction products, obtained by X-ray fluorescence analysis on a Shimadzu EDX-7000 spectrometer, showed that some reactions proceed incompletely and need the selection of optimal conditions. The potential commercial benefits of processing phosphogypsum by carbonization were defined for products such as calcium carbonate or its derivatives.
DOI: 10.31897/PMI.2023.1 The development of a comprehensive approach to preventing the pollution of natural objects is necessary due to the high requirements of environmental legislation for the discharge of industrial wastewater. Adsorbents are used in various industries to extract heavy metals from wastewater. In this study the possibility of using saponite clay as a...
The solution of the sludge utilization problem and yield increase at processing plants have great importance today all over the world. Disasters associated with the tailings dams failures have madeus develop technologies of tailings sludge utilization as a commercial product, reducing the environmental damage on the regions of mineral extraction. This research aimed to provide new data, methods and an analytical approach to solve the saponite sludge accumulation problem on mining enterprises with silicate coagulant to increase the rate of cycle water clarification for the enrichment process and the recycling of sludge to reduce its hazardous effect. Samples were taken in the deposit located in the north of the European part of Russia, where diamond bearing ore contain montmorillonite minerals, mostly saponite, which is considered to be a perspective secondary product. The content of this mineral in the sludge is above 20 wt.%. Saponite is a clay mineral with the general chemical formula (Ca,Na)0.3(Mg, Fe2+)3(Si, Al)4O10(OH)2·4H2O. The mineral has high adsorption, ion exchange, and catalytic and filtration properties; due to the developed diffuse layer, saponite particles are highly stable in an aqueous medium—the resulting suspension is highly stable and has slow sedimentation. During the research, a positive effect on the sedimentation process of clay saponite particles was established, due to the introduction of a coagulant containing 70% tricalcium silicate, at a dosage of 2 g/dm3 coagulant; the degree of purification of water containing the saponite clay suspension is 99%. The condensed sediment after the thermal drying and with the limestone addition can be used again as a coagulant or secondary product with enhanced properties;therefore, the sludge will be processed, and not stored.
The paper describes the issues associated with waste generated during steel production and processing, in particular the dust from electric arc furnaces (EAF). An effective solution for the disposal of such waste is its involvement in processing to obtain valuable products. This paper studies the physical and chemical properties of EAF dust produced during the smelting of metallized pellets and captured by the dust and gas cleaning system of the steel-smelting shop at the Oskol Electrometallurgical Combine, Belgorod Region. The results obtained in the study of the chemical and disperse compositions of dust, the microstructure of the surface made it possible to propose the use of dust as a raw material for coagulant production. The conditions of acid-thermal treatment of dust are determined, contributing to the partial dissolution of iron (II), (III), and aluminium compounds, which ensure the coagulation processes during wastewater treatment. Model solutions show high efficiency (> 95 %) of water treatment from heavy metal ions by modified EAF dust.
The study is devoted to studying the adsorption properties of a thermally modified carbon-containing material of schungite in combination with a coagulant aluminum oxychloride for further operation in a combined wastewater treatment. The carbon sorbent traditionally used in water sorption treatment - hydroanthracite and untreated ground natural mineral shungite has been studied. Its thermal modification in order to increase the specific surface and total pore volume to increase the cleaning efficiency was carried out on the basis of the obtained experimental data on adsorption on natural shungite and hydroanthracite. In the course of the experiment, the thermal modification of natural adsorbent based on the schungite from Zazhoginsky deposit in Karelia was studied. A comparative study of the adsorption of iron (III) was made on the following adsorbents: anthracite, natural schungite, thermally modified schungite. The isotherms adsorption of iron (III) as a function of the equilibrium concentration were obtauned. The degree of extraction of the metal cations from standardized test solution using initial and modified natural adsorbents was determined. The use of oxychloride coagulant is suggested to clean the water up to the required indicators. On the basis of experimental data, a two-stage wastewater treatment scheme is proposed using the modified schungite and aluminum oxychloride coagulant. Following the results of experiments, it is possible to draw a conclusion that modified shungite adsorbs in comparison with anthracite 1.4 times higher and twice above, then natural shungite without heat treatment. The value of the maximum adsorption is of the great importance for the modified shungite, which almost in 7 times more the maximum adsorption received for anthracite and by 5.6 times – for not processed natural shungite.
Предприятие ПАО «Севералмаз» занимается разработкой алмазного месторождения вблизи природоохранной зоны, следовательно, требует обеспечения эффективной и безопасной технологии добычи полезных ископаемых. Для разработки и внедрения данной технологии были отобраны пробы оборотной и карьерной воды на предприятии и подвержены рентгенофазовому, рентгенофлуорисцентному и гранулометрическому анализу. На основании результатов этих анализов были подобраны и разработаны коагулянты, способные превратить огромную массу пустой породы, производимой предприятием, во вторичный продукт. Применение сульфатов щелочных металлов для разделения глинистых тонкодисперсных частиц, представленных преимущественно сапонитом, является довольно перспективным. Измерены скорость осаждения и изменение кислотности суспензии, а также произведено сравнение с традиционными коагулянтами. Осадки, обработанные сульфатами щелочных металлов, подвергли рентгенофазовому и рентгенофлуорисцентному анализу, а также предположили возможный механизм процесса уплотнения частиц. Сапонит -глинистый минерал монтморилонитовой группы, содержащий большое количество магния, обладающий сорбционными свойствами. Получаемые в ходе разработки минеральные глинистые осадки являются перспективным сырьем для целого ряда вторичных продуктов. Частицы сапонита, вследствие их геометрических и физико-химических характеристик, образуют крайне устойчивую к седиментации суспензию. Применение сульфатов щелочных металлов оказывается существенно эффективнее, чем применение традиционных промышленных коагулянтов, а применение кальцийсодержащих шламов в качестве утяжелителей позволяет интенсифицировать процесс. Получаемые осадки содержат достаточное количество калия и магния для создания на основе сапонитового осадка минерального калий-магниевого удобрения, высушенная глина может служить основой для морозостойкого бетона. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .