Plasma electrolytic oxidation (PEO) treatment of Mg alloys improves their wear resistance by increasing their surface hardness, but also leads to high coefficient of friction (COF) values. The sliding counterfaces and the conditions under which PEO-coated Mg alloys operate affect their COFs. PEO-coated AZ31 alloy sliding against hydrogenated DLC (a-C-H) coated steel yields a low COF of 0.13 under the ambient conditions. The current study investigates the effect of the test temperature on the tribological behavior of PEO-coated AZ31 Mg samples sliding against the a-C-H coated counterface at temperatures up to 300 °C. According to the COF vs. wear rate diagram constructed in the temperature range of 25–250 °C, lower COF values and wear rates were exhibited by PEO-coated AZ31 sliding against a-C-H compared to uncoated AZ31 sliding against a-C-H, and PEO coated AZ31 sliding against an uncoated ASTM 52100 steel. The PEO-coated AZ31 produced the lowest COF of 0.03 at 200 °C. The application of PEO to the Mg alloy automotive cylinder bores running against DLC-coated piston rings and/or PEO-coated Mg alloy pistons running against DLC-coated bores could provide a new approach for the prevention of seizure and hot scuffing in lightweight engines in the temperature range between 150–250 °C.
1 August 2010 in International Journal of Machine Tools and Manufacture
This study investigated the friction and wear characteristics of a plasma electrolytic oxidation (PEO)-coated Mg–Al alloy (AZ31) in sliding contact against steel using graphene nanoplatelets (GNPs) containing ethanol as a lubricant. The results revealed that the typically high coefficient of friction (COF) of PEO-coated surfaces under dry sliding (0.74) was notably reduced to 0.18 during the sliding tests conducted in GNP-free ethanol. When the ethanol contained 5 × 10−4 wt.% GNPs, the COF of the uncoated AZ31 alloy further dropped to 0.17. The PEO-coated surfaces achieved a significantly lower COF of 0.07 and demonstrated a marked reduction in wear rate, attributed to the formation of a tribolayer incorporating graphene. These findings highlight the significant potential of GNP-incorporated ethanol to improve the tribological performance of PEO-coated AZ31, presenting a promising avenue for advancing lightweight, sustainable, and efficient automotive technologies.
10 November 2020 in Tribology - Materials, Surfaces & Interfaces
Tribological behaviour of Ti–6Al–4V alloy sliding against WC-Co was evaluated by employing WS2 nanoparticles blended in a cutting fluid used for machining of this alloy. Pin-on disk tests were carried out under boundary-lubricated condition using a cutting fluid (70% water and 30% oil) blended with WS2 nanoparticles (CF + WS2). When a cutting fluid with ≥ 0.5 wt.% WS2 was used, the COF of the tribosystem was reduced compared to CF + 0%WS2. The lowest COF of 0.05 was obtained when 1.0 wt.% WS2 was used. Low and stable COF values were accompanied by the formation of a tribolayer incorporating WS2 and WO3 on the WC-Co surfaces. During orthogonal machining of Ti–6Al–4V using CF + 1.0%WS2, a tribolayer with the similar composition was formed on the cutting edge of the WC-Co tool and the average cutting force was reduced by 35% compared to cutting with CF + 0%WS2. Machining with CF + 1.0%WS2 produced thinner chips. Other improvements in machining performance attained using CF + 1.0%WS2 included reduction of adhesive wear on the tool and a lower roughness of the machined surface. GRAPHICAL ABSTRACT