A technique based on electrochemical etching of metal is suggested for balancing the first four harmonics of nonuniform mass distribution in a metal cylindrical toothless resonator for a cylindrical resonator gyroscope (CRG). An algorithm for removing mass from the resonator surface has been designed with allowance made for analytically calculated angle and depth of the resonator inclined immersion into an electrochemical bath and its rotation about the cylinder axis of symmetry.
This paper addresses issues related to the choice of materials for the fabrication of high-Q mechanical resonators. It has been shown that the best material combining a low level of thermoelastic losses and small bulk internal friction is silica glass. Given its excellent dissipative characteristics and relatively low cost, silica glass prepared via high-temperature hydrolysis of silicon tetrachloride in an oxygen–hydrogen flame is the most promising material for such resonators.
The aim of this article is to study the nature of the defects arising on the surface of silica glass during mechanical processing followed by chemical cleaning and etching. Such defects manifest themselves as a narrow Raman peak near 85 cm–1. It is shown that chemical etching of the ground surface of silica glass leads to the formation of microcrystalline defects embedded at the depth of the near-surface layer. Defects of this kind create heterogeneities in structure of the atomic network and increase internal friction in silica glass mechanical resonators. This phenomenon should be taken into account when developing the technology for fabrication of high-Q resonators. This article is protected by copyright. All rights reserved
This paper presents our results on ultrasound-induced changes in the surface topography of quartz glass studied using the Allan variance method. The use of this method has made it possible to quantitatively assess roughness components corresponding to surface defects of particular size. Prolonged ultrasonic treatment of quartz glass plates at a power density of 10 W/cm2 has been shown to cause significant changes in surface roughness: the profile height due to small surface defects, 0.125 μm in size, increased by about 40% and the one due to large defects (12 μm) decreased by about 30%. The observed changes in surface topography seem to be related to cavitation destruction of large surface defects by local cumulative jets.