Various substituents could be diastereoselectively introduced into the 5-position of pipecolic acid via electrophilic or free-radical-initiated addition to the carbon–carbon double bond of endocyclic enecarbamates derived from pipecolic acid. This study allowed the diastereoselective synthesis of both cis- and trans-5-guanidino pipecolates, which were designed as constrained arginine mimetics and whose potential inhibition of nitric oxide synthase (NOS) was evaluated with three NOS isoforms.
This study revisits and optimizes silicon/carbon/poly(acrylic acid) – (PAA) composite anode preparation for lithium-ion batteries. The objective is to analyze the specific impact of the high energy ball milling step on the PAA polymer binder and on the composite anode electrochemical behavior in order to improve cycling performance. For this purpose, three commercial PAAs with 15, 450 and 3000 kg mol−1 average molar masses are considered. PAA structural alterations induced by ball milling are investigated by SEC, IRTF, 1H NMR and TGA. It appears that PAA 15k is slightly degraded while higher molar mass PAAs are significantly deteriorated. An innovative optimized formulation, combining (1) ball milling of carbon and Si only followed by (2) magnetic stirring of this mixture with PAA and a dispersant is proposed and compared to an all ball milling formulation. The first step is essential to get good electrochemical performance and the second enables the maintenance of polymer integrity. The highest electrochemical capacity retention after 20 cycles is obtained for the PAA 450k-based electrode (84%) compared with those of PAA 15k and PAA 3000k of 62% and 29%, respectively. Interestingly, this capacity retention is also significantly improved compared with that of the corresponding PAA 450k all ball milling formulation electrode (65%).
The semi-synthetic polysaccharide carboxymethylcellulose (CMC) is one of the most studied and effective polymer binders for silicon-based anodes in Li-ion batteries. The formulation of the corresponding composite negative electrode with an appropriate mixture of electroactive silicon, a CMC binder and a carbon additive is mandatory to ensure a good electrical conductivity. Blending is commonly realized by a highly energetic ball milling treatment of these three aforementioned components. This type of mixing reduces the size of the obtained particles and can also potentially agglomerate them. Morever, it allows the formation of a nanostructured mixture which is essential for both the silicon activation and to achieve good electrochemical performance. However, such strong treatment can also cause a significant degradation of the polymer chains, as we have recently demonstrated for polyacrylic acid (PAA). In the present work, the structural and chemical effects of this mechanical grinding on three commercial CMCs ranging from 90 to 700 kg mol−1 were investigated. All the polymers were characterized using SEC-MALLS, FTIR spectroscopy, MALDI-TOF mass spectrometry and TGA-MS thermal analysis. In all cases, a huge average molecular weight decrease was noticed, leading to the appearance of a bimodal distribution with low (52–72 kg mol−1) to very low molecular weight populations (1–1.8 kg mol−1). From these results, two formulations of a negative electrode were compared, one with ball milling of the three compounds and another one including only ball milling steps for silicon and carbon. After the correlation of the characteristics of this negative electrode composite with the electrochemical results, it was demonstrated that a high number of functions for supramolecular or covalent linkages are keypoints of the herein anode performance. Low molecular weight CMC derivatives (about 64 kg mol−1) obtained by ball milling treatment led to higher stability of the electrode.