An amorphous graphite material has been predicted from molecular dynamics simulation using ab initio methods. Carbon materials reveal a strong proclivity to convert into a network and then layer at temperatures near 3000 K within a density range of ca. . Each layer of amorphous graphite is a monolayer of amorphous graphene including pentagons and heptagons in addition to hexagons, and the planes are separated by about . The layering transition has been studied using various structural and dynamical analyses. The transition is unique as one of partial ordering (long range order of planes and galleries, but topological disorder in the planes). The planes are quite flat, even though monolayer amorphous graphene puckers near pentagonal sites. Interplane cohesion is due partly to non-Van der Waals interactions. The structural disorder has been studied closely, especially the consequences of disorder to electronic transport. It is expected that the transition elucidated here may be salient to other layered materials.
14 October 2020 in Environmental Science & Technology
Amorphous carbon nanotubes (a‐CNT) with up to four walls and sizes ranging from 200 to 3200 atoms have been simulated, starting from initial random configurations and using the Gaussian Approximation Potential. The important variables (like density, height, and diameter) required to successfully simulate a‐CNTs were predicted with the machine learning random forest technique. The width of the a‐CNT models ranged between 0.55–2 nm with an average inter‐wall spacing of 0.31 nm. The topological defects in a‐CNTs were analyzed and new defect configurations were observed. The electronic density of states and localization in these phases were discussed and delocalized electrons in theπsubspace were identified as an important factor for inter‐layer cohesion. Spatial projection of the electronic conductivity favors axial transport along connecting hexagons, while non‐hexagonal parts of the network either hinder or bifurcate the electronic transport. A vibrational density of states was calculated and is potentially an experimentally comparable fingerprint of the material. The appearance of a low‐frequency radial breathing mode was discussed and the thermal conductivity at 300 K was estimated using the Green‐Kubo formula.
21 November 2016 in Industrial & Engineering Chemistry Research
Land application of manure can be a sustainable supply chain practice that improves soil quality by recycling important nutrients contained in animal waste. Yet, runoff of phosphorus and nitrogen nutrients contained in the animal waste has contributed to significant watershed eutrophication. Recovery of the dissolved nutrient species as a condensed solid fertilizer product would increase sustainability of the agricultural supply chain, while reducing watershed pollution. This study was conducted to evaluate the recovery of phosphorus (primarily) as struvite using an electrochemical process while varying temperature, applied cathodic potential, turbulence and Ca2+ concentration. High phosphorus recovery with high current efficiency and low specific energy consumption was possible at 20 °C, −1.1 V vs Ag/AgCl at the cathode, and a Reynolds number of 9150 in the absence of Ca2+ when the Mg:N:P ratio was 1.37:1:1. Further, a thermodynamic model of the waste solution indicated an increase in Ca2+ concentration, which impedes struvite recovery, can be negated by increasing dissolved Mg2+ concentration and operating at a pH below NH3 volatilization.