In the current study, four formulae (BNS1-BNS4) of butenafine (BTF) loaded nanosponges (NS) were fabricated by solvent emulsification technology, using different concentration of ethyl cellulose (EC) and polyvinyl alcohol (PVA) as a rate retarding polymer and surfactant, respectively. Prepared NS were characterized for particle size (PS), polydispersity index (PDI), zeta potential (ZP), entrapment efficiency (EE) and drug loading (DL). Nanocarrier BNS3 was optimized based on the particle characterizations and drug encapsulation. It was further evaluated for physicochemical characterizations; FTIR, DSC, XRD and SEM. Selected NS BNS3 composed of BTF (100 mg), EC (200 mg) and 0.3% of PVA showed, PS (543 ± 0.67 nm), PDI (0.330 ± 0.02), ZP (−33.8 ± 0.89 mV), %EE (71.3 ± 0.34%) and %DL (22.8 ± 0.67%), respectively. Fabricated NS also revealed; polymer-drug compatibility, drug-encapsulation, non-crystalline state of the drug in the spherical NS as per the physicochemical evaluations. Optimized NS (BNS3) with equivalent amount of (1%, w/w or w/v) BTF was incorporated into the (1%, w/w or w/v) carbopol gel. BTF loaded NS based gel was then evaluated for viscosity, spreadability, flux, drug diffusion, antifungal, stability and skin irritation studies. BNS3 based topical gels exhibited a flux rate of 0.18 (mg/cm2.h), drug diffusion of 89.90 ± 0.87% in 24 h with Higuchi model following anomalous non-Fickian drug release. The BNS3 based-gel could be effective against pathogenic fungal strains.

Olmesartan medoxomil (OLM) is one of the prominent antihypertensive drug that suffers from low aqueous solubility and dissolution rate leading to its low bioavailability. To improve the oral bioavailability of OLM, a delivery system based on ethylcellulose (EC, a biobased polymer) nanosponges (NSs) was developed and evaluated for cytotoxicity against the A549 lung cell lines and antihypertensive potential in a rat model. Four OLM-loaded NSs (ONS1-ONS4) were prepared and fully evaluated in terms of physicochemical properties. Among these formulations, ONS4 was regarded as the optimized formulation with particle size (487 nm), PDI (0.386), zeta potential (ζP = −18.1 mV), entrapment efficiency (EE = 91.2%) and drug loading (DL = 0.88%). In addition, a nanosized porous morphology was detected for this optimized system with NS surface area of about 63.512 m²/g, pore volume and pore radius Dv(r) of 0.149 cc/g and 15.274 Å, respectively, measured by nitrogen adsorption/desorption analysis. The observed morphology plus sustained release rate of OLM caused that the optimized formulation showed higher cytotoxicity against A549 lung cell lines in comparison to the pure OLM. Finally, this system (ONS4) reduced the systolic blood pressure (SBP) significantly (p < 0.01) as compared to control and pure OLM drug in spontaneously hypertensive rats. Overall, this study provides a scientific basis for future studies on the encapsulation efficiency of NSs as promising drug carriers for overcoming pharmacokinetic limitations.

The current study aimed to prepare a topical gel containing solid lipid nanoparticles (SLNs) encapsulating fluoxetine for diabetic wound healing effects. Fluoxetine (FX) was loaded into SLNs by employing an emulsion solvent evaporation technique using stearic acid as a lipid, and soya lecithin as a surfactant. SLNs were then evaluated for particle size, polydispersity index (PDI), zeta potential (ZP), percent entrapment efficiency (%EE), percent drug loading (%DL), and in vitro drug release. The optimized SLN (FS3) composed of FX (100 mg), SA (150 mg), and SA (100 mg) displayed mean particle size (467.3 ± 2.2nm), PDI (0.435 ± 0.02), ZP (−32.2 ± 4.47mV), EE (95.8 ± 3.38%), and DL (16.4 ± 2.4%). FTIR and DSC studies denote drug-polymer compatibility and the amorphous nature of FX in the SLNs. The drug release at 24 h was found to be (98.89 ± 2.57%) which followed the fickian diffusion mechanism. SLN (FS3) was further loaded into carbopol gel and tested for pH, spreadability, and extrudability of pharmaceutical parameters. In-vitro release of FX from the SLN gel and plain gel was compared, diabetic wound healing gel (DWH) showed sustained drug delivery. An in vivo study was also performed for DWH gel in streptozotocin-induced diabetic rats. Histopathological examination exhibited DWH gel-treated wounds have increased hydroxyproline, cellular proliferation, a rise in the number of blood vessels, and the level of collagen synthesis. Thus, DWH gel-loaded SLN encapsulated with FX could be a potential carrier for the effective treatment and management of diabetic wounds.

Tamarindus indica L., is widely used tree in ayurvedic medicine. Here, we aimed to understand the presence of important constituents in seeds and peel of Tamarind fruits and their biological activities. Hence, seeds and peel of Tamarind fruits are used for further extraction process by soxhlet method (chloroform and ethyl acetate solvents). Results suggest that the ethyl acetate extract (seeds) consists of terpenoids (72.29 ± 0.513 mg/g), phenolic content (68.67 ± 2.11 mg/g) and flavonoids (26.36 ± 2.03 mg/g) whereas chloroform extract (seeds) has terpenoids (42.29 ± 0.98 mg/g). Similarly, chloroform extract (peel) has terpenoids (25.96 ± 3.20 mg/g) and flavonoids (46.36 ± 2.03 mg/g) whereas ethyl acetate extract (peel) has terpenoids (62.93 ± 0.987 mg/g). Furthermore, anti-inflammation activity results revealed that the chloroform extract of peel was found to be more effective with IC₅₀ of 226.14 µg/ml by protein denaturation analysis and with IC₅₀ of 245.5 µg/ml on lipoxygenase inhibition activity. Chloroform extract (peel and seeds) shown better antioxidant activity using DPPH than ethyl acetate extract (peel and seeds). Ethyl acetate extract of seeds showed impressive potency by inhibiting the growth of fungus, Candida albicans. Additionally, ethyl acetate extract of seeds showed impressive potency inhibiting the growth of Escherichia coli than Bacillus cereus. GC–MS analysis shown the existence of diverse set of phytochemicals in each extract. Overall, comparative studies highlight the effectiveness of seeds extracts than peel extracts. Moreover, GC–MS results suggest that the seeds and peel extracts (chloroform and ethyl acetate) contains a wide range of compounds (including flavonoids, isovanillic acid, fatty acids and phenolic compounds) which can be utilized for therapeutic purpose.

The objective of this work was to develop sustained-release Ca-alginate beads of apigenin using sodium alginate, a natural polysaccharide. Six batches were prepared by applying the ionotropic gelation technique, wherein calcium chloride was used as a crosslinking agent. The beads were evaluated for particle size, drug loading, percentage yield, and in vitro drug release. Particle size was found to decrease, and drug entrapment efficiency was enhanced with an increase in the polymer concentration. The dissolution study showed sustained drug release from the apigenin-loaded alginate beads with an increase in the polymer proportion. Based on the dissolution profiles, BD6 formulation was optimized and characterized for FTIR, DSC, XRD, and SEM, results of which indicated successful development of apigenin-loaded Ca alginate beads. MTT assay demonstrated a potential anticancer effect against the breast cancer MCF-7 cell lines. The antimicrobial activity exhibited effective inhibition in the bacterial and fungal growth rate. The DPPH measurement revealed that the formulation had substantial antioxidant activity, with EC50 value slightly lowered compared to pure apigenin. A stability study demonstrated that the BD6 was stable with similar (f2) drug release profiles in harsh condition. In conclusion, alginate-based beads could be used for sustaining the drug release of poorly water-soluble apigenin while also improving in vitro antitumor, antimicrobial, and antioxidant activity.

The objective of this study was to synthesize silver nanoparticles from the leaves of Tridax procumbens and develop its topical gels using chitosan to investigate the wound healing efficacy concomitant with the histopathological study. Green synthesized silver nanoparticles (AgNPs) were prepared by reacting silver nitrate (0.3 M) with leaf extract and characterized by particle analysis, FTIR, XRD, SEM, BET, and TGA. The results revealed formed AgNPs were nano-sized (138 ± 2.1 nm), monodispersed (PDI: 0.460 ± 0.3), inter-particle repulsion (zeta: −20.4 ± 5.20 mV), stabilized, crystalline and, spherical with size ranging from 80–100 nm as per SEM micro photos. The BET analysis of AgNPs presents the surface area (12.861 m²/g), pore volume (0.037 cc/g), and pore radius (24.50 nm).TGA results show a loss of 13.39% up to 300 °C. The topical formulation was developed by loading AgNPs in chitosan-based gels, evaluated by pH, thermal cycling, centrifugal, and spreadability tests. AgNPs chitosan gels results showed skin compatibility, higher stability, and spreading ability. The maximum antibacterial zone of inhibition was found to be 25 ± 0.98 mm for bacillus subtitles and 30 ± 1.99 mm for Klebsiella pneumoniae, respectively. Nanosilver-containing gel also showed excellent compatibility with erythrocytes. Excision wound model was used to assess the wound healing property of the developed AgNP gels, the results of which indicated a significantly progressive healing process in test-group of animals treated with chitosan-based gels containing AgNPs. A histopathological study further confirmed the almost normal skin structure of treated animal tissue compared to standard and negative control. Thus, green synthesized AgNPs loaded chitosan-based topical gel can potentially be used for wound healing application.