Carlos Heras

Dr. Carlos Heras

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2016 in AIP Conference Proceedings
Verified
Conference Paper
Open access
Aránzazu Fernández-GarcíaAránzazu Fernández-García
Aránzazu Fernández-García
FSFlorian Sutter
Florian Sutter
AHAnna Heimsath
Anna Heimsath
MMMarco Montecchi
Marco Montecchi
FSFabienne Sallaberry
Fabienne Sallaberry
CHCarlos Heras
Carlos Heras
The most relevant parameter to properly characterize solar mirrors is the solar-weighted near-specular reflectance. As this parameter cannot be directly measured with off-the-shelf instruments, a simplified procedure to be applied for highly specular solar mirrors is proposed in this paper. The approach, based on two criteria, was experimentally employed to check a wide variety of solar reflector materials. Only those mirrors with known high specularity passed the criteria, indicating that the proposed method is suitable.

8 November 2021 in IEEE Sensors Journal
Verified
Journal Article
Closed access
JPJavier Preciado-Garbayo
Javier Preciado-Garbayo
PSPascual Sevillano
Pascual Sevillano
CHCarlos Heras
Carlos Heras
JSJesús Subías
Jesús Subías
DSDavid Sanahuja
David Sanahuja
JMJuan J. Martinez
Juan J. Martinez
Sensing range and response bandwidth are the main parameters that define the performance of distributed optical fiber sensors. In this work, a novel scheme based on the use of in-line optical repeaters is proposed to extend the sensing range of distributed acoustic sensors (DAS) based in direct-detection coherent optical time-domain reflectometry (DD C-OTDR). The proposed regenerators comprise three different stages that reamplify the incoming pulse amplitude, synchronize the acquisition using the incoming pulse and also detect the backscattered signal from the next span. With repeaters placed every 40 km along a fiber under test (FUT), we have achieved a total sensing range above 120 km while keeping a pulse frequency of 2.5 kHz (1.25 kHz bandwidth). At the end of each segment of the FUT we experimentally demonstrate the correct measurement of a 15 nε stimulus, with and an average degradation lower than 3 dB per fiber span. The experimental results show that an extension of the sensing range in DD C-OTDR can be achieved without reducing the frequency response bandwidth or increasing the scheme complexity.

1 October 2016 in Solar Energy
Verified
Journal Article
Open access
ISIñigo Salinas
Iñigo Salinas
CHCarlos Heras
Carlos Heras
CACarlos Alcañiz
Carlos Alcañiz
DIDavid Izquierdo
David Izquierdo
NMNoelia Martínez
Noelia Martínez
RARafael Alonso
Rafael Alonso
This contribution presents a new field Solar Spectrum Reflectometer for solar-weighted specular reflectance characterization of planar, spherical or parabolic mirrors. This reflectometer is designed to provide fast and reliable field measurements and to be valid for any type of mirror currently installed in concentrated solar power systems, including parabolic trough, Stirling dish and central receiver power plants. The optical design of the Solar Spectrum Reflectometer, which includes 6 LEDs in the VIS–NIR band, is described, and its tolerance to variations in the geometrical parameters of the mirrors discussed and evaluated. The contribution of diffuse reflection and its impact on the measured reflectance is also calculated for different concentrated solar power systems.

4 September 2025 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Open access
SASalvador Andrés
Salvador Andrés
CHCarlos Heras
Carlos Heras
AOAndrés Ocabo
Andrés Ocabo
JLJorge Lanzuela
Jorge Lanzuela
RMRubén Martínez
Rubén Martínez
RARafael Alonso
Rafael Alonso
This paper presents the implementation of a C band frequency-modulated continuous wave (FMCW) radar system, utilizing software-defined radio (SDR) hardware and integrated with a five-element multi-long-baseline interferometer (MLBI) receiver, for the detection and 3D tracking of passive moving targets. A key aspect is the generation of low-jitter high signal-to-noise-and-distortion-ratio (SINAD) signal, which significantly enhances the radar´s performance for angle of arrival (AOA) detection and micro-Doppler signature (MDS) estimation. The high signal quality achieved enables the detection and 3D tracking of low-radar cross section (RCS) targets, such as small drones, at distances up to 800 meters without requiring high radar power. Additionally, this work demonstrates the effectiveness of a simple phase line assignment algorithm to mitigate errors in the AoA measurement of passive moving targets even when the MLBI geometry deviates from its optimal configuration. The performance of the radar system was evaluated in an open-field test using a DJI Mavic 3, and the results highlight the significant potential of this radar concept for medium-cost 3D tracking and MDS identification applications.

1 January 2006 in Optics Letters
Verified
Journal Article
Closed access
PDF file
CHCarlos Heras
Carlos Heras
JSJ. Subías
J. Subías
JPJ. Pelayo
J. Pelayo
FVF. Villuendas
F. Villuendas
We present the results of an experiment for frequency and polarization dependence characterization of nonlinear cross-phase-modulation (XPM) effects in optical fibers. The measurement technique is based on the direct analysis of high-resolution optical spectra of a signal wave that is phase modulated by an intensity-modulated pump wave. Measurement results provide experimental confirmation of the scalar character, over the whole resonant frequency range, of the electrostrictive contribution to the nonlinear refractive index. Also, the results confirm experimentally the relation describing the polarization dependence of the Kerr contribution to XPM in non-polarization-maintaining fibers.

27 November 2023 in Journal of Physics D: Applied Physics
Verified
Journal Article
Closed access
RCRocio Chueca
Rocio Chueca
RARaul Alcain
Raul Alcain
CHCarlos Heras
Carlos Heras
ISIñigo Salinas
Iñigo Salinas
Perimetrally uncoated windows can be a simple and low cost solution to the problem of radio frequency (RF) transmission in low-e glass when the requirements are not too demanding. However, this kind of non-uniform and relatively large structures are difficult to characterize experimentally. The aim of this work is to develop and experimentally verify a method for the simulation of the RF transmission of perimetrally uncoated windows. We propose to study these windows as a composition of four rectangular apertures in a metallic sheet. Using numerical simulations, we are able to obtain the transmission coefficient of these apertures. Then, a multilayer model based on transmission line theory is used to consider the effect of the different glazings and cameras which can be part of a window. Finally, the results of this study are compared to the measurements of complete windows in the 1000 MHz–6000 MHz frequency range.