The fifth-generation (5G) wireless cellular network is expected to be ready for commercialization within this year. The huge spectrum enabled by the millimetre-wave (mm-Wave) technology is expected to introduce a hype in data usage per user. The 5G is also expected to concurrently support a wide variety of services; however, the practical trade-offs associated with concurrent services require further investigations. In this work, a physical layer (PHY) design to support visible light communications is considered to efficiently support concurrent services that are essential to serve the needs of the sixth-generation (6G) network. A novel communication technique, i.e. mixed-carrier communication (MCC), is proposed. MCC enables simultaneous wireless services such as broadband access, low-rate internet-of-things connectivity, device-free sensing, and device-based localization. This study presents, firstly, a thorough investigation of the design procedure of the novel MCC PHY, secondly, the spectral profile of MCC towards proper spectrum management and interference analysis, and thirdly, performance evaluation based on modelling, simulation and an experimental proof-of-concept. The design steps recommend that the system performance degrades beyond a signal-to-noise ratio (SNR) threshold. For instance, SNR of 25.1 dB and 2.6652 optical power ratio between the communications signal and the driving envelope, for 64-quadrature amplitude modulation (64-QAM), are recommended to avoid performance degradation due to clipping. Simulation results show an interference-immune performance of a properly managed spectrum. For a bit-error-rate (BER) of 10 −3 , an SNR penalty of 2–5 dB is observed for different interference scenarios. The experimental measurements illustrate a high-quality signal of 21 dB SNR at 50 cm and 10 −3 BER using 64-QAM.
Hybrid wireless networks are foreseen to play a major role in the visioning and planning of the sixth generation (6G) network. Most of the 6G applications are human-centric, and thus high security and privacy are key features. Recently, physical layer (PHY) security has become an emerging area of research. This work introduces a novel, to the best of our knowledge, PHY security approach called wireless link pairing (WiLP). In WiLP, signals received from both air interfaces in a hybrid radio frequency and optical network are required for successful signal reconstruction and processing at the receiver. The transmitted packets based on the IEEE 802.11 standards are redesigned, and improvements in performance are validated via simulations and experimental measurements using software-defined radio platforms. The obtained results demonstrate improvements in bit-error rate (BER) and the secrecy capacity for multiple modulation and coding schemes.
Recently, research on sixth-generation (6G) networks has gained significant interest. 6G is expected to enable a wide-range of applications that fifth-generation (5G) networks will not be able to serve reliably, such as tactile Internet. Additionally, 6G is expected to offer Terabits per second (Tbps) data rates, 10 times lower latency, and near 100% coverage, compared to 5G. Thus, 6G is expected to expand across all available spectrums including terahertz (THz) and optical frequency bands. In this manuscript, mixed-carrier communication (MCC) is investigated as a novel physical layer (PHY) design for 6G networks. The proposed MCC version in this study is based on visible light communication (VLC). MCC enables a unified transmission PHY design to connect devices with different complexities, simultaneously. The design trade-offs and the required signal-to-noise ratio (SNR) per individual modulation schemes embedded within MCC are investigated. The complexity analysis shows that a conventional optical OFDM receiver can capture the high-speed bit-stream embedded within MCC. For a forward error correction (FEC) bit-error-rate (BER) threshold of , MCC is optimized to maximize the spectral efficiency by embedding 2-beacon phase-shift keying (2-BnPSK) within an MCC envelope on top of 12 bits per beacon position modulation (BPM) symbol.