The performance of a concentrated solar power plant is strongly driven by its heat storage capacity and is evolving through the development of new salt mixtures. Molten nitrates, which have already proved their high potential, can be further improved in terms of economic and environmental aspects, with the mitigation of toxic compounds and a higher electricity generation capability. In this work, stability range and energy density characterisations were performed on the nitrate ‘Solar’ salt, along with its life cycle assessment, environmental impact, and cost analysis.
Ternary low melting point mixtures with the addition of LiNO3 and Ca(NO3)2 have been presented as direct system candidates for CSP technologies due to having better physical and chemical properties than those of Solar Salt. In this study, thermal, physical and chemical properties are measured as is the corrosive behavior of stainless alloy VM12 (Cr 12%) when in contact with Solar Salt, 60% NaNO3-40% KNO3 (wt.%) and ternary 46% NaNO3-19% Ca(NO3)2-35% LiNO3 (wt.%). Gravimetric weight change measurements were performed on the test specimens, which were tested under accelerated fluid conditions (0.2 m s−1) at 500 °C for 2000 h. This research confirms the potential of this novel formulation as a thermal storage medium and validates the suitability of ferritic VM12-SHC stainless steel as a structural material for CSP technology with Solar Salt. Meanwhile, the results obtained by scanning electron microscopy and X-ray diffraction indicate a reduction in the protective character of the oxide layer formed on this alloy when the medium contains calcium and lithium components.
A detailed analysis of the melting point and thermal degradation of a ternary mixture of carbonates to which various percentages of NaOH were added is presented. To this end, Differential Scanning Calorimetry (DSC) and Thermogravimetric Analysis (TGA) were carried out. Experimental results show that the melting point of the prepared salts can be down to below 450 °C with their decomposition temperatures around 900°C. The new kinds of mixed molten salts have a lower melting point and a slightly higher decomposition temperature, but the obtained improvements are not as large as expected. Therefore, it can be concluded that NaOH does not substantially improve the temperature operation range of the initial carbonate mixture.