The degree and depth of fracturing of the lithospheres of Mars, Mercury, and the Moon remain poorly known. It is these two properties, however, that govern the mechanical behavior of a planetary lithosphere. Considering the lithosphere as a cohesive rock mass that consists of small and large blocky, interlocked rock fragments, as opposed to an intact body or a body entirely lacking cohesion, provides insight into the effect of lithospheric fracturing on tectonic processes on these bodies. Characterization of the near‐surface lithospheric brittle strength that incorporates the degree of fracturing is necessary for a realistic assessment of the lithospheric response to global contraction resulting from interior secular cooling. Such an assessment shows that all of these bodies could have accommodated substantial amounts of global contraction prior to the formation of thrust fault‐related landforms. In fact, their lithospheres were sufficiently strong so as to experience changes in radius of as much as 2.2 ± 0.4 km (Mars), 2.1 ± 0.4 km (Mercury), and 1.4 ± 0.3 km (the Moon) prior to the onset of widespread thrust faulting. These values imply that the process of global contraction begins before any evidence of it is established in the geologic record, requiring an earlier onset, and for Mars and Mercury a faster initial strain rate, of global contraction than previously thought. Such results add a heretofore unrecognized component of planetary radial decrease with implications for timing and strain rate to studies of global contraction on Mars, Mercury, and the Moon, in particular, and to planetary bodies, in general.
On planets with little erosion, thrust faults produce broad, asymmetric, positive‐relief, linear to arcuate ridges—often referred to as lobate scarps—that remain largely unaltered, such that their topographic expressions are a measure of the structural uplift caused by the displacement and associated country rock deformation of the faults. Here we map and systematically assess the structural relief of 24 thrust faults across Mars to infer their growth behavior. Our mapping indicates that the majority of individual thrust faults have simple, linear map traces with lengths of up to ~450 km but that some thrust faults form systems of up to 1,400 km in length. For the most topographically pronounced landforms, the structural relief developed above the fault is as great as ~3,400 m. We then relate topographic measurements to the displacement on the underlying fault planes to study the displacement variations along the fault length. We find a variety of displacement distribution shapes of the fault systems, which we attribute to differences in fault growth that include unrestricted and restricted growth, linkage, and/or fault interaction. Finally, we relate the maximum displacements (Dmax) determined for each of the faults to their respective fault length (L) to establish a maximum displacement‐to‐length relationship. The observed scaling characteristics and order‐of‐magnitude scatter of ourDmax/Ldata are not uncommon for fault populations on Earth and tie in well with the map patterns, tectonic geomorphology, and systematic along‐strike displacement distributions to have grown in a basement‐block faulting style found in intraplate tectonic settings on Earth.
Asteroid 4 Vesta hosts two sets of enormous troughs, Divalia Fossae that encircle two‐thirds of the equator and Saturnalia Fossae located in the northern hemisphere. These troughs were interpreted as grabens, thus invoking faulting. The trough sizes, their linear arrangement, and overall morphology leave no doubt that their origin is tectonic, but structures other than faults have not been considered. To test if they are fault‐related or formed by accommodating opening‐mode displacement (i.e., jointing) without subsequent shear, we investigate the map patterns, cross‐sectional geometries, and variations of relief and width along the trough lengths. Relief and width could relate to the vertical displacement of faults and aperture of joints, respectively, and they therefore reveal differences in fracturing behavior. We analyzed six major troughs on Vesta, four belonging to Divalia Fossae, and two to Saturnalia Fossae. No map patterns are diagnostic of faulting or jointing. For each pair of trough‐bounding scarps, the maximum relief does not lie at the trough center, and the two maxima occur at different positions along the trough. In contrast, troughs are widest near the centers of the troughs. These characteristics are inconsistent with graben formation but are consistent with jointing. Furthermore, rock‐mechanical calculations that account for Vesta's low gravitational acceleration and degree of fracturing reveal that faulting is not favored to be initiated at depths above at least ∼3 but as much as 55 km within Vesta's lithosphere. Therefore, jointing or mixed‐mode fracturing, both involving opening‐mode displacements, are more plausible fracturing mechanisms for the Divalia Fossae.