Dynamic simulation of district heating and cooling networks has an increased importance in the transition towards renewable energy sources and lower temperature district heating grids, as both temporal and spatial behavior need to be considered. Even though much research and development has been performed in the field, there are several pitfalls and challenges towards dynamic district heating and cooling simulation for everyday use. This article presents the experiences from developing and working with a city-scale simulator of a district heating grid located in Luleå, Sweden. The grid model in the case study is a physics based white-box model, while consumer models are either data-driven black-box or gray-box models. The control system and operator models replicate the manual and automatic operation of the combined heat and power plant. Using the functional mock-up interface standard, a co-simulation environment integrates all the models. Further, the validation of the simulator is discussed. Lessons learned from the project are presented along with future research directions, corresponding to identified gaps and challenges.
In this work, we present a modification for the classic and phasor extremum seeking control algorithms in order to improve the accuracy by removing or reducing the convergence error. The modulation signals were replaced by a sum of sinusoids in order to remove the equilibrium shift in the controlled variable of the averaged system. The convergence error is calculated as a function of the number of sinusoids used in the modulation signal. A simulation example is presented to illustrate the improvement.
In this letter, we address a multi-objective on-line optimization problem for unknown dynamical systems by providing a generalization of the Pareto seeking controller (PSC). The idea of the PSC is to drive the system to the Pareto front in the absence of knowledge of the values of the objectives or the input values to achieve Pareto optimality. Two special cases are presented, for two objectives and three objectives. A stability analysis is presented for the case of two objectives and two inputs, which shows that the controller practically drives the system into the neighborhood of the Pareto front, for any initial condition. Two simulation examples for the special cases are also presented.
4 January 2024 in IEEE Transactions on Control Systems Technology
Simulation of thermal dynamics in city-scale district energy grids often becomes computationally prohibitive for long simulation runs. Most current model order reduction methods offer limited interpretability with regards to the nonreduced system and are not in general applicable for varying flow rates, multiple producers, or changing flow directions. This article presents a graph perspective on modeling of district energy networks. Based on spectral graph theory, a novel method for model order reduction of district energy systems is proposed. The method approximates the solution of an optimization problem, minimizing the coefficients of the local truncation error for the advection equation. Furthermore, a method for calculating the intracluster temperature distribution is presented. It is shown that the method can be used to reduce the thermal dynamic model of a city-scale energy grid, resulting in a coarser temporal and spatial resolution, with a significant decrease in simulation time. The relative root-mean-square error (rRMSE) was 2.5% for the temperature in the evaluation scenario, comparing the reduced-order system with the nonreduced system at the instances of the coarser time step.