Piezoelectric energy harvesting has gained attention owing to its effectiveness at harvesting electrical energy from various energy sources. Especially, with the increasing demand for smart highways,...
1 January 2008 in Journal of Adhesion Science and Technology
This paper describes the development of a mathematical model and application of the numerical results to predict the adhesion forces between wheels and rails. The adhesion force is realized on a small area of a wheel–rail contact. Many factors have an influence on the adhesion process for these surfaces (e.g., environment, pollution, parameters and conditions of railway vehicle service, track, etc.). The paper focuses on different modelling aspects. Experimental investigation on the process of friction in the contact zone was performed. The data obtained were used to create a mathematical model. The adhesion, which is dependent on load from the wheel to the rail, temperature, friction conditions in the contact zone and wheel slip, was calculated. Finally, a quick method to determine the adhesion force between the wheels (wheel pair) of a railway vehicle and rails (rail track) is presented.
Measurement of the mechanical properties of human skin in vivo is challenging. Moreover, those with regard to excitation frequency have been rarely reported thus far. In this study, a vibration-based experimental method was employed to measure the viscoelastic properties with regard to the excitation frequency. Pieces of human skin and skeletal muscle excised from cadavers immediately post mortem were stored in a sealed container. As the experiment began, they were removed from the container and used to measure the viscoelastic properties as time elapsed. Young's moduli of the samples of human skin tissue that were immediately removed from the container were found to be similar to those obtained with in-vivo indentation methods. They were also found to be approximately one-third of those of human skeletal muscles. The viscoelastic properties of human skin were found to remain almost constant within the frequency range up to 120 Hz and are similar to those of porcine tissue. Young's moduli of the human skin and skeletal muscle were also found to reach the maximum values approximately five days post mortem. However, the loss factor of the human skin did not vary significantly as time elapses.