A cost-effective synthesis was used to grow Zn_xCu_1−xO_y nanostructures. DFT calculations show that charge transfer along with changes in Fermi level facilitate H₂ gas sensing, which is further enhanced by Zn doping.

Hybrid metal oxide nano‐ and microstructures exhibit novel properties, which make them promising candidates for a wide range of applications, including gas sensing. In this work, the characteristics of the hybrid ZnO‐Bi₂O₃ and ZnO‐Zn₂SnO₄ tetrapod (T) networks are investigated in detail. The gas sensing studies reveal improved performance of the hybrid networks compared to pure ZnO‐T networks. For the ZnO‐T‐Bi₂O₃ networks, an enhancement in H₂ gas response is obtained, although the observed p‐type sensing behavior is attributed to the formed junctions between the arms of ZnO‐T covered with Bi₂O₃ and the modulation of the regions where holes accumulate under exposure to H₂ gas. In ZnO‐T‐Zn₂SnO₄ networks, a change in selectivity to CO gas with high response is noted. The devices based on individual ZnO‐T‐Bi₂O₃ and ZnO‐T‐Zn₂SnO₄ structures showed an enhanced H₂ gas response, which is explained on the basis of interactions (electronic sensitization) between the ZnO‐T arm and Bi₂O₃ shell layer and single Schottky contact structure, respectively. Density functional theory‐based calculations provide mechanistic insights into the interaction of H₂ and CO gas molecules with Bi‐ and Sn‐doped ZnO(0001) surfaces, revealing changes in the Fermi energies, as well as charge transfer between the molecules and surface species, which facilitate gas sensing.

Noble metals and their oxide nano-clusters are considered to be the most promising candidates for fabricating advanced H₂ gas sensors. Through this work, we propose a novel strategy to grow and modulate the density of PdO/PdO₂ nanoparticles uniformly on nanostructured Pd-doped ZnO (ZnO : Pd) films by a one-step solution approach followed by thermal annealing at 650 °C, and thus to detect ppm-level H₂ gas in a selective manner. The gas sensing properties of such hybridized materials showed that the PdO-functionalized ZnO samples offer significantly improved H₂ gas sensing properties in an operating temperature range of 25–200 °C. The deposition of ZnO : Pd films via a simple synthesis from chemical solutions (SCS) approach with an aqueous bath (at relatively low temperatures, <95 °C) is reported. Furthermore, the functionalization of palladium oxide nanoclusters by a simple but highly effective approach on ZnO : Pd film surfaces was performed and is reported here for the first time. The morphological, structural, vibrational, optical, chemical, and electronic properties were studied in detail and the mixed phases of palladium oxide nanoclusters on the ZnO surface were found. Sensor studies of the ZnO : Pd samples (in the range of 25–350 °C operating temperature) showed good selectivity to H₂ gas, especially in the range of higher temperatures (>150 °C, up to 350 °C); however, the PdO/PdO₂ mixed phases of the nanocluster-modified surface ZnO : Pd films showed a much better selectivity to H₂ gas, even at a lower operating temperature, in the range of 25–150 °C. For such PdO-functionalized ZnO : Pd films, even at room temperature, a gas response of ∼12.7 to 1000 ppm of H₂ gas was obtained, without response to any other reducing gases or tested vapors. The large recovery time of the samples at room temperatures (>500 s) can be drastically reduced by applying higher bias voltages. Furthermore, we propose and discuss the gas sensing mechanism for these structures in detail. Our study demonstrates that surface functionalization with PdO/PdO₂ mixed phase nanoclusters–nanoparticles (NPs) is much more effective than only the Pd doping of nanostructured ZnO films for selective sensing applications. This approach will pave a new way for the controlled functionalization of PdO/PdO₂ nanoclusters on ZnO : Pd surfaces to the exact detection of highly explosive H₂ gas under various atmospheres by using solid state gas sensors.