Jianhua Qiao

Ms. Jianhua Qiao

Taiyuan University of Science and Technology, College of Electronic Information Engineering
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 December 2021 in IEEE Sensors Journal
Verified
Journal Article
Closed access
JHJun Hou
Jun Hou
JQJianhua Qiao
Jianhua Qiao
XHXinglong Han
Xinglong Han
One of the most important researches in wireless sensor networks is energy saving. The clustering algorithm can efficiently save energy. However, most of the existing clustering algorithms use a fixed cluster head election algorithm and perform each round of clustering, so that unsuitable nodes are continuously elected as cluster heads, leading to rapid exhaustion of node energy and short network life. In order to solve these problems, this paper proposes an Energy-saving Fuzzy Clustering Routing algorithm (EFCR) for wireless sensor networks,which designs two types of clustering, Clustering Type1 and Clustering Type2, and alternately executes them in different rounds according to the threshold. Clustering Type1 considers the parameters that affect the energy consumption of the node: the distance from the node to the base station, the number of neighbor nodes of the node, and the remaining energy of the node as fuzzy inputs, and calculates the fitness of the node as a cluster head through fuzzy inference to avoid the occurrence of unsuitable nodes being successively elected as cluster heads. Clustering Type2 performs data transmission by trusting the last round of cluster heads, which reduces the number of control data packets in each round of clustering and reduces the overall energy consumption of the network. This paper conducted simulations in four different scenarios, compared other clustering algorithms of the same type, and analyzed the remaining energy of the network, the number of surviving nodes, and the life of the network. The results show that EFCR algorithm is better than others.

3 May 2018 in IEEE Access
Verified
Journal Article
Open access
JQJianhua Qiao
Jianhua Qiao
XZXueying Zhang
Xueying Zhang
Compressive data gathering (CDG) based on compressed sensing (CS) theory for wireless sensor networks (WSN) greatly reduces the amount of data transmitted compared with the traditional acquisition method that each node forwards the collected data directly to the next node. CDG combined with sparse random projection can further reduce the amount of data and thus prolong the lifetime of the WSN. The method of randomly selecting projection nodes as cluster heads to collect the weighted sum of sensor nodes outperforms the non-CS (without using CS) and hybrid-CS (applying CS only to relay nodes that are overloaded) schemes in decreasing the communication cost and distributing the energy consumption loads. However, the random selection of projection nodes causes the overall energy consumption of the network to be unstable and unbalanced. In this paper, we propose two compresseive data gathering methods of balanced projection nodes. For WSN with uniform distribution of nodes, an even clustering method based on spatial locations is proposed to distribute the projection nodes evenly and balance the network energy consumption. For WSN with unevenly distributed nodes, an even clustering method based on node density is proposed, taking into account the location and density of nodes together, balancing the network energy and prolonging the network lifetime. The simulation results show that compared with the random projection node method and the random walk method, our proposed methods have better network connectivity and more significantly increased overall network lifetime.

6 April 2018 in IEEE Access
Verified
Journal Article
Open access
JQJianhua Qiao
Jianhua Qiao
XZXueying Zhang
Xueying Zhang
Random projection based on compressed sensing can reduce the amount of data transmitted in a wireless sensor network (WSN), and efficient routing can reduce the network traffic. Thus, this paper presents a Random projection-Polar coordinate-Chain routing (RPC) method. The method uses polar coordinates to locate nodes, establishes a chain structure to form a route, and applies random projection to achieve the compressed data collection. In a WSN, the sink is the center of the data collection. With the sink as the pole, the polar coordinates can be used to determine the orientation of each node relative to the sink so that nodes can be searched under certain conditions. By adopting the chain topological structure, the establishment of the chain through the greedy algorithm reduces the energy consumption and complexity. Based on the comparative analysis, a four-quadrant chain routing method combining the polar radius and polar angle is proposed for smaller networks. For large-scale networks, a routing algorithm combining the sector and inner circle is proposed. Then, according to the random projection theory, the weighted sum of the random projections of each row of the corresponding measurement matrix in each partition is transmitted to the sink. The sink has collected all measurements of each partition to complete the signal reconstruction. In this method, the route is formed by searching in the zones according to the polar radius and the polar angle, which avoids the roundabout route between distant nodes and reduces the energy consumption of the network. By comparing the RPC method with other related methods and the simulation experiments for different types of routing, the proposed method is proved to be time and energy efficient.

21 September 2021 in Measurement Science and Technology
Verified
Journal Article
Closed access
JQJianhua Qiao
Jianhua Qiao
JHJun Hou
Jun Hou
JGJushuai Gao
Jushuai Gao
YWYan Wu
Yan Wu
The localization problem is a key supporting technology in wireless sensor network (WSN). The performance of commonly used positioning algorithms in WSN in terms of node density, beacon node ratio and different terrain is firstly analyzed and compared in this paper. The analysis shows that the magnitude of the positioning error of the trilateration method based on the received signal strength indicator (RSSI) ranging technology is 10 −15 , which is far lower than other positioning algorithms, but the node proportion that cannot be located is 20%–50% or so, which is much higher than other algorithms. Therefore, an improved trilateration positioning method based on RSSI ranging (ITRSS) is proposed, that is, the unknown nodes that have been located is used as new beacon nodes to locate other unknown nodes. MATLAB simulation shows that the positioning error of the proposed ITRSS method is only reduced by an order of magnitude, moreover, the proportion of nodes that cannot be located is reduced to about 1%, which is only some remote individual node out of the communication range in the area. The Zigbee network established by the CC2530 chip is used for preliminary experimental verification. The experimental results show that the nodes that could not be located at first can be located, and the positioning error does not exceed the set threshold of 3 m. Thus shows the proposed ITRSS method is of feasibility and effectiveness, which help to improve the positioning capability of the entire WSN network.

1 August 2016
Verified
Conference Paper
Closed access
JQJianhua Qiao
Jianhua Qiao
XZXueying Zhang
Xueying Zhang
The design of measurement matrices is one of the key contents of the compressed sensing (CS) theory. This paper constructs a new dual-structured measurement matrix-unit array + random matrix, by combining the advantages of the random measurement matrices with high recovery probability and the structured measurement matrices of low storage. The experiments show that the reconstruction errors can be gotten lower through using the measurement matrix designed than those of the simple application of the random measurement matrix. Then a method of sub-frame overlapping is proposed for reconstructing the entire signal, which can remove large errors caused by unit array in the measurement matrix, and ensure the stability of the whole signal reconstruction. Simulation results demonstrate that the signal to noise ratio (SNR) is increased significantly and the reconstruction performance of signal is improved remarkably.