This study experimentally investigated the effects of cascade inlet velocity on the distribution and the level of the heat transfer coefficient on a gas turbine blade tip. The tests were conducted in a transient turbine test facility at Korea Aerospace University, and three cascade inlet velocities—30, 60, and 90 m/s—were considered. The heat transfer coefficient was measured using the transient IR camera technique with a linear regression method, and both the squealer and plane tips were investigated. The results showed that the overall averaged heat transfer coefficient was generally proportional to the inlet velocity. As the inlet velocity is increased from 30 m/s to 60 m/s and 90 m/s, the heat transfer coefficient increased by 11.4% and 25.0% for plane tip, and 26.6% and 64.1% for squealer tip, respectively. However, the heat transfer coefficient near the leading edge of the squealer tip and the reattachment region of the plane tip was greatly affected by the cascade inlet velocity. Therefore, heat transfer experiments for a gas turbine blade tip should be performed under engine simulating conditions.

In this study, we numerically investigated the effects of design parameters, such as the strut geometry or diffusion angle, on the performance of an industrial turbine exhaust diffuser. Turbine exhaust diffusers are commonly used to change the kinetic energy of exhaust gases from the outlet of turbine stages into the static pressure. The turbine exhaust diffuser investigated in this work consisted of an annular diffuser with five identical struts equally spaced around the front circumference and a conical diffuser with a hub extension at the rear. Four design parameters were considered and several values for each parameter were tested in this study. The aerodynamic performances of the studied diffusers were evaluated according to their pressure recovery coefficients and rates of total pressure loss. Contours for the velocity, pressure, and entropy increase were plotted and compared for the various diffuser shapes. The numerical results showed that the strut thickness and the axially swept angle of the strut significantly influence the aerodynamic performance of the turbine exhaust diffuser, whereas the strut lean angle and the diffuser hade angle are less important.