The use of composite materials has seen widespread adoption in modern aerospace industry. This has been facilitated due to their favourable mechanical characteristics, namely, low weight and high stiffness and strength. For broader implementation of those materials though, the out-of-autoclave production processes have to be optimized, to allow for higher reliability of the parts produced as well as cost reduction and improved production speed. This optimization can be achieved by monitoring and controlling resin filling and curing cycles. Photonic Integrated Circuits (PICs), and, in particular, Silicon Photonics, owing to their fast response, small size, ability to operate at higher temperatures, immunity to electromagnetic interference, and compatibility with CMOS fabrication techniques, can offer sensing solutions fulfilling the requirements for composite material production using carbon fibres. In this paper, we demonstrate a passive optical temperature sensor, based on a 220 nm height Silicon-on-Insulator platform, embedded in a composite tool used for producing RTM-6 composite parts of high quality (for use in the aerospace industry). The design methodology of the photonic circuit as well as the experimental results and comparison with the industry standard thermocouples during a thermal cycling of the tool are presented. The optical sensor exhibits high sensitivity (85 pm/°C), high linearity (R2 = 0.944), and is compatible with the RTM-6 production process, operating up to 180 °C.
Light detection and ranging (Lidar) is a key enabling technology for autonomous vehicles and drones. Its emerging implementations are based on photonic integrated circuits (PICs) and optical phased arrays (OPAs). In this work, we introduce a novel approach to the design of OPA Lidar antennas based on Si3N4 grating couplers. The well-established TriPleX platform and the asymmetric double stripe waveguide geometry with full etching are employed, ensuring low complexity and simple fabrication combined with the low-loss advantages of the platform. The design study aims to optimize the performance of the grating coupler-based radiators as well as the OPA, thus enhancing the overall capabilities of Si3N4-based Lidar. Uniform and non-uniform grating structures are considered, achieving θ and φ angle divergences of 0.9° and 32° and 0.54° and 25.41°, respectively. Also, wavelength sensitivity of 7°/100 nm is achieved. Lastly, the fundamental OPA parameters are investigated, and 35 dBi of peak directivity is achieved for an eight-element OPA.