We propose an analytical model for the force-indentation relationship in viscoelastic materials exhibiting a power law relaxation described by an exponent n, where n = 1 represents the standard viscoelastic solid (SLS) model and n < 1 represents a fractional SLS model. To validate the model, we perform nanoindentation measurements of polyacrylamide gels with atomic force microscopy (AFM) force curves. We found exponents n < 1 that depend on the bisacrylamide concentration. We also demonstrate that the fitting of AFM force curves for varying load speeds can reproduce the dynamic viscoelastic properties of those gels measured with dynamic force modulation methods.

Two-dimensional materials exhibit great potential for high-performance electronics applications and the knowledge of their thermal properties is extremely necessary, since they are closely related to efficient heat dissipation and electron-phonon interactions. In this study we report the temperature-dependence of the out-of-plane A_1g Raman mode of suspended and supported CVD-grown single-crystalline tungsten diselenide (WSe₂) monolayer. The A_1g phonon wavenumber is linearly red-shifted for temperature ranging from 98 to 513 K, with first-order temperature coefficients β of -0.0044 and -0.0064 cm⁻¹/K for suspended and supported monolayer WSe₂, respectively. The higher β module value for supported sample is attributed to the increase of the phonon anharmonicity due to the phonon scattering with the surface roughness of the substrate. Our analysis of the temperature-dependent phonon dynamics reveal the influence of the substrate on thermal properties of monolayer WSe₂ and provide fundamental information for developing of atomically-thin 2D materials devices.

Non-standard diesel blends can be harmful to the environment and human health. In this context, a simple analytical method to estimate the biodiesel mixture ratio in diesel was developed based on impedance spectroscopy (IS) associated with interdigitated sensors. In this article, four different interdigitated sensors with varied comb spacing (G) were simulated using the COMSOL Multiphysics software. Based on finite element simulations, four interdigitated electrode architectures were manufactured and evaluated. The best geometry was chosen according to theoretical data simulations, and its interdigitated electrodes were manufactured for the compositional evaluation of pseudo-binary biodiesel–diesel mixtures. According to the X-ray powder diffraction technique, the deposition of the conductive layer (Au⁰) over the surface of the dielectric substrate (SiO₂) did not alter its phase composition. In the analysis of AFM and SEM, it was possible to observe irregular edges on the electrodes, possibly related to the manufacturing process of the thin layers and mechanical stability. Another characteristic observed in the AFM images was the height of the step of the gold layer of the sensor. Several cross sections were obtained, and the mean step value was 225.71 ± 0.0032 nm. Although there were differences in the roughness, the whole sensor had nanometric roughness. Based on the finite element method simulation performed, it can be assumed that the geometric parameters more suitable for the manufacturing of the electrode are W = 20 µm, L = 1000 µm, G = 50 µm, and N = 40 digits. The electrical characterization performed by impedance spectroscopy showed that we could differentiate between biodiesel and diesel fuels and their pseudo-binary mixtures in the low-frequency region.

Nanodrugs have in recent years been a subject of great debate. In 2017 alone, almost 50 nanodrugs were approved for clinical use worldwide. Despite the advantages related to nanodrugs/nanomedicine, there is still a lack of information regarding the biological safety, as the real behavior of these nanodrugs in the body. In order to better understand these aspects, in this study, we evaluated the effect of polylactic acid (PLA) nanoparticles (NPs) and magnetic core mesoporous silica nanoparticles (MMSN), of 1000 nm and 50 nm, respectively, on human cells. In this direction we evaluated the cell cycle, cytochemistry, proliferation and tubulogenesis on tumor cells lines: from melanoma (MV3), breast cancer (MCF-7, MDA-MB-213), glioma (U373MG), prostate (PC3), gastric (AGS) and colon adenocarcinoma (HT-29) and non-tumor cell lines: from human melanocyte (NGM), fibroblast (FGH) and endothelial (HUVEC), respectively. The data showed that an acute exposure to both, polymeric nanoparticles or MMSN, did not show any relevant toxic effects on neither tumor cells nor non-tumor cells, suggesting that although nanodrugs may present unrevealed aspects, under acute exposition to human cells they are harmless.