Problems related to unsaturated soils are frequently encountered in geotechnical or environmental engineering works. In most cases, for simplicity, one can study the problems by considering the suction effects on volume change or shear strength under isothermal conditions. Often, under these conditions, a temperature-independent water retention curve is considered in the analysis — obviously a simplification. When the temperature changes are too significant to be ignored, it is necessary to account for the thermal effects. This note presents a method for controlling suction with the vapour equilibrium technique at different temperatures. First, calibration of various saturated saline solutions was carried out at temperatures ranging from 20 °C to 60 °C. A mirror psychrometer was used to measure relative humidity generated by saturated saline solutions at different temperatures. The results obtained were in good agreement with the data from the literature. This information was then used to determine the water retention properties of MX80 clay, which showed that the retention curve shifts downward with increasing temperature.Key words: vapour equilibrium technique, hygrometer, water retention curve, temperature effects, compacted bentonite.

In the present work, the shear behaviour of soils and the soil–concrete interface is investigated through direct shear tests at various temperatures. A conventional direct shear apparatus, equipped with a temperature control system, was used to test sand, clay, and the clay–concrete interface at various temperatures (5, 20, and 40 °C). These values correspond to the range of temperatures observed near thermoactive geostructures. Tests were performed at normal stress values ranging from 5 to 80 kPa. Results show that the effect of temperature on the shear strength parameters of soils and the soil–concrete interface is negligible. A softening behaviour was observed during shearing of the clay–concrete interface, which was not the case with clay specimens. The peak strength of the clay–concrete interface is smaller than the ultimate shear strength of clay.