In this article, vibration of thin-walled beams with arbitrary open cross-section shape is investigated. Based on the beam element model accounting for warping and flexural–torsional coupling, analytical solutions for different boundary conditions are derived for higher free vibration modes in bending, torsion and flexural–torsional coupled modes. In the model, the effects of rotational inertial kinematic terms are considered. The finite element approach of the model is also investigated. Three-dimensional beams with seven degrees of freedom per node are adopted in the mesh process. Free vibration and forced vibration analyses are possible. In forced vibration, the behaviour of the beams is studied in the frequency domain using the steady-state method (modal analysis). Damping is considered using the Rayleigh model. The model is validated by comparing the results to benchmark solutions found in the literature and to other recent numerical and experimental results. Additional finite element simulations are performed by means of commercial softwares (Abaqus and Adina). In slender unrestrained beams, the vibration behaviour is predominated by torsion and lateral bending modes. In design, recourse to braces is a good compromise. This solution is discussed, and improvement of the vibration behaviour in the presence of intermediate braces is confirmed. Application of higher vibration modes in building and bridge design is outlined. The effects of the number and distribution of the intermediate braces to improve structural stability against vibration behaviour is outlined.

This paper addresses the flexural–torsional stability of functionally graded (FG) nonlocal thin-walled beam-columns with a tapered I-section. The material composition is assumed to vary continuously in the longitudinal direction based on a power-law distribution. Possible small-scale effects are included within the formulation according to the Eringen nonlocal elasticity assumptions. The stability equations of the problem and the associated boundary conditions are derived based on the Vlasov thin-walled beam theory and energy method, accounting for the coupled interaction between axial and bending forces. The coupled equilibrium equations are solved numerically by means of the differential quadrature method (DQM) to determine the flexural–torsional buckling loads associated to the selected structural system. A parametric study is performed to check for the influence of some meaningful input parameters, such as the power-law index, the nonlocal parameter, the axial load eccentricity, the mode number and the tapering ratio, on the flexural–torsional buckling load of tapered thin-walled FG nanobeam-columns, whose results could be used as valid benchmarks for further computational validations of similar nanosystems.

This paper aims to investigate, in large displacement and torsion context, the nonlinear dynamic behavior of thin-walled beams with open cross section subjected to various loadings by high-order implicit solvers. These homotopy transformations consist to modify the nonlinear discretized dynamic problem by introducing an arbitrary invertible pre-conditioner $ [K^\star] $ and an arbitrary path following parameter. The nonlinear strongly coupled equations of these structures are derived by using a $ 3D $ nonlinear dynamic model which accounts for large displacements and large torsion without any assumption on torsion angle amplitude. Coupling complex structural phenomena such that warping, bending-bending, and flexural-torsion are taken into account. Two examples of great practical interest of nonlinear dynamic problems of various thin-walled beams with open section are presented to validate the efficiency and accuracy of high-order implicit solvers. The obtained results show that the proposed homotopy transformations reveal a few number of matrix triangulations. A comparison with Abaqus code is presented.