Oral squamous cell carcinoma (OSCC) is the most prevalent oral malignant tumor worldwide. An early diagnosis can have a major positive impact on its prognosis. Human saliva contains cytokines, DNA and RNA molecules, circulating cells, and derivatives of tissues and extracellular vesicles, among other factors that can serve as biomarkers. Hence, the analysis of saliva may provide useful information for the early diagnosis of OSCC for its prognosis. The objective of this review was to determine the potential usefulness of salivary biomarkers (cytokines and microRNA) to diagnose OSCC and improve its prognosis. A combination of salivary miRNA and proteomic data could allow a definitive and early diagnosis to be obtained. However, there remains a need to optimize and standardize the protocols used to quantify miRNAs.

Background and objective: Primary stability (PS) is remarkable for secondary stability and implant success. Surgical technique modifications seem to improve primary stability, especially in poor quality bone. The aim of this study was to compare the insertion torque (IT) and implant stability quotients (ISQ) of implants placed with underpreparation, expanders, and standard surgical instrumentation in different bone types. Material and methods: This randomized controlled clinical trial enrolled 108 patients (n=108 implants) distributed in three study groups: group 1 (n=36) underpreparation technique, group 2 (n=36) expander technique, and group 3 (n=36) conventional drilling. IT was recorded with a torque indicator. ISQ was recorded with resonance frequency analysis immediately after surgery. Results: ISQ values were associated with the patient’s bone quality and were higher in bone quality type II (76.65) and type III (73.60) and lower in bone quality type IV (67.34), with statistically significant differences (p<0.0001). Lower stability results were obtained when conventional drilling (69.31) was used compared to the use of underpreparation (74.29) or expanders (73.99) with a level of significance of p=0.008 and p=0.005, respectively. Conclusions: The surgical technique influences the PS when there is low-quality bone. In low-quality bones, conventional drilling obtains lower ISQ values. Clinical relevance: Replace the conventional drilling technique for an alternative, underpreparation or expanders, in low-quality bone in order to achieve greater primary stability.

Implant stability is one of the main indicators of successful osseointegration. Although it has been measured in numerous studies, there has been little research on implant stability in regenerated bone. The study compares primary and secondary stability between implants placed in regenerated versus native bone and evaluates the influence of bone quality on the results. Sixty implants were placed in 31 patients: 30 implants inserted in native bone (non-regenerated) after a healing period of at least 6 months post-exodontia and 30 inserted in regenerated bone at 6 months after grafting with xenograft. Resonance frequency analysis (RFA) was used to obtain implant stability quotient (ISQ) values at baseline (implant placement), 8 weeks, and 12 weeks. Statistically significant differences were found between implants placed in regenerated bone and those placed in native bone at all measurement time points (p < 0.05). ISQ values were significantly influenced by bone quality at baseline (p < 0.05) but not at 8 or 12 weeks. Greater stability was obtained in implants placed in native bone; however, those placed in regenerated bone showed adequate primary and secondary stability for prosthetic loading. Bone quality influences the primary but not secondary stability of the implants in both native and regenerated bone.

Cyanoacrylate tissue adhesive is proposed to promote soft tissue healing in oral surgery and minimize complications (pain, inflammation, and bleeding) associated with wound healing by secondary intention. The objective was to compare cyanoacrylate tissue adhesive (test group) with suture (control group) in terms of postoperative complications, operative time, and wound healing in the palatal donor area after harvesting a de-epithelialized gingival graft. A randomized controlled clinical trial was performed in 24 patients randomly assigned to one of two study groups. Data were gathered on wound bleeding, operative time, postoperative pain, inflammation, hyperesthesia, necrosis, and donor area healing time. Operative time was almost 50% shorter in the tissue adhesive cyanoacrylate group, a significant between-group difference (p = 0.003). Spontaneous bleeding in the donor area during the first 24 h was observed in 11.1% of the tissue adhesive cyanoacrylate group versus 88.9% of the suture group—a significant difference. No significant between-group difference was observed in postoperative pain, inflammation, or degree of healing over time. There were no cases of hyperesthesia or wound necrosis. Utilization of tissue adhesive cyanoacrylate rather than suture in palatal de-epithelialized gingival graft harvesting reduces postoperative bleeding during the first 24 h, as well as the operative time.

Periodontal disease encompasses gingivitis and periodontitis and is one of the most common chronic infections in the adult population. This study aimed to evaluate the influence of Spanish propolis extract (EEP) on the effect of the clinical and microbiological parameters as an adjuvant to scaling and root planning in patients undergoing supportive periodontal therapy (SPT). Forty chronic periodontitis patients were randomly assigned into two groups for the treatment. In the control group (n = 20), the sites were treated by scaling and root planing followed by gingival irrigation with physiological saline and in the test group (n = 20), the sites were treated by scaling and root planing followed by subgingival placement of EEP. At baseline (BL), bleeding on probing positive (BOP+) sites with probing pocket (PPD) ≥ 4 mm were defined as study sites. Plaque index, PPD, BOP, clinical attachment level (CAL), and subgingival plaque were evaluated at BL and 1 month later. The results showed a significant clinical improvement (p < 0.05) in the PPD, CAL and BOP+ comparing them with BL and one month after the periodontal treatment and a significant reduction (p < 0.05) for Tannerella forsythensis, Porphyromonas gingivalis, Prevotella intermedia and Treponema denticola in both groups. In addition, the improvement of clinical parameters was observed with subgingival use of EEP and also statistically significant differences between groups were observed (p < 0.05) such as reductions of BOP+ % and reduced counts of T. forsythensis and P. gingivalis, considered as the “key pathogens” for the periodontal diseases. Our results suggest prophylactic and therapeutic potential for EEP against periodontal diseases, improving clinical parameters, reducing gingival bleeding and decreasing bacterial counts of T. forsythensis and P. gingivalis. The subgingival use of EEP represents a promising modality as an adjuvant in periodontal therapy to avoid microbial resistance and other adverse effects.

Thermoplastic resin fiber composites have an easy fabrication process, good mechanical properties, and compatible stiffness to tooth dentin. However, they have not yet attracted much interest in the field of dentistry. The current study was carried out to test a new proposed approach to manufacture a fiber reinforced composite endodontic post and evaluate its flexural strength through a two-point inclined loading test. The proposed fiber post manufacture approach depends upon a braiding technique of the glass fibers’ (GF) reinforcing component with thermoplastic polypropylene (PP) resin fibers that will later represent the resin matrix after thermal melting. Posts were made of different core (70%) and sheath (30%) construction (PP/GF ratios) using three different GF types and seizing pre-treatment to both fiber types. Two-point inclined loading test at 45 °C applied force angle was used to test the posts’ flexural strength. Fiber posts (1.6 mm in diameter) with pure GF (de-sized starch E-GF and pre-silanized S-GF) core, and sheath construction with higher PP/GF ratios, showed the significantly highest two-point bending strength (56.67 ± 4.89 and 53.96 ± 1.81 MPa, respectively), among experimental posts groups (except for the commercial control posts). However, posts with PP core type showed the lowest values (21.59 ± 1.86 and 16.54 ± 1.94 MPa for de-sized and E-glass sheath fibers, respectively). Based on these findings, the proposed approach was reliable in producing fiber-reinforced composite post with the desired dimensions and fiber distribution. Post construction with a pure GF core and higher PP/GF ratio showed considerably higher flexural strength and GF volume fraction comparable to commercial available post types.