An analytical method to calculate and optimize the performance of a multi-mirror combined solar dish collector is proposed in this work. It is based on the method of directly calculating the optical efficiency of a reflecting point, which can consider the influence of many factors. The distribution of the reflected solar intensity is obtained by the convolution of the actual solar intensity distribution and Gaussian distribution of the optical error. Then, the optical efficiency for a single mirror is calculated through integration over the total area of the mirror, and the method is validated by the SolTrace code. It is a rather quick method that reduces the amount of calculation and keeps high accuracy. The heat loss per unit area for the cavity receiver is assumed to be constant at a definite operation temperature for performance analysis and optimization. Taking a 62.25 m2 combined dish system with 249 square spherical mirrors as an example, the effects of system focal length, open radius of receiver, optical error, and focal length of the mirror on the system intercept factor and efficiency are studied. An optimization model is developed for maximizing the annual average net thermal efficiency. If the mirrors used have the same focal length for reducing the manufacture cost, when the optical error is 2 mrad, the net thermal efficiency and the intercept factor of the optimized system are 85.87% and 98.60%, respectively, while the concentration ratio is about 2000.
The characteristic analysis of the flux formed by the heliostat in the optical system is the basis in design and optimization of the whole system. In this paper, our research subject is a pilot installation of the point-focus Fresnel system, which is a new optical design between the tower system and the dish system. For the optical system, it is very important to accurately calculate the solar flux density distribution on the receiver plane. Aiming at the case that the focal length of the heliostat is not equal to the distance from the center of the heliostat to the center of the receiver plane, based on the projection, an approximate calculation method is proposed. Using the method to calculate the solar flux density distribution of the point-focus Fresnel system, and the results are compared with that calculated by SolTrace code, it is found that the solar flux density distribution of both is relatively consistent in shape and numerical value, which verifies the accuracy of the method and it can be used for design and optimization of the point-focus Fresnel system.