There are several widely used devices for controlled contusion of the spinal cord, including the Ohio State University device, the University of British Columbia multi-mechanisms injury device, the New York University (NYU) impactor, and the Infinite Horizon (IH) impactor. Although various devices and protocols have been used to generate consistent injury severities, further investigation of the relationship between the key parameters of different spinal cord injury (SCI) contusion devices (e.g., drop height in the NYU impactor and impact force in the IH impactor) will improve our understanding of SCI mechanisms. A three-dimensional finite element model of the rat spinal cord from T9 to T10 that included the white and gray matters, dura mater, and cerebrospinal fluid was developed to investigate the von-Mises stress, maximum principal strain, and maximum displacement of the spinal cord for the drop height in the NYU impactor and the impact force in the IH impactor. A quantitative relationship was established as a conversion equation between two key parameters—i.e., the drop height and the impact force—in the NYU and IH impactors from regression equations for peak von-Mises stress, peak maximum principal strain, and maximum displacement in the spinal cord with respect to drop height and impact force with very high coefficients of determination. The consistent correlation was represented as a simple equation (Force = (28.2 ± 3.2) · Height^(0.83±0.07)) under the experimental conditions of a 10-g rod in the NYU impactor and an impact velocity of 125 mm/sec in the IH impactor. Thus, the key biomechanical parameter for a contusion device can be converted or translated to that of another device to analyze experimental results from multiple contusion devices.

Clinically, spinal cord injuries (SCIs) are radiographically evaluated and diagnosed from plain radiographs, computed tomography (CT), and magnetic resonance imaging. However, it is difficult to conclude that radiographic evaluation of SCI can directly explain the fundamental mechanism of spinal cord damage. The von-Mises stress and maximum principal strain are directly associated with neurological damage in the spinal cord from a biomechanical viewpoint. In this study, the von-Mises stress and maximum principal strain in the spinal cord as well as the cord cross-sectional area (CSA) were analyzed under various magnitudes for contusion, dislocation, and distraction SCI mechanisms, using a finite-element (FE) model of the cervical spine with spinal cord including white matter, gray matter, dura mater with nerve roots, and cerebrospinal fluid (CSF). A regression analysis was performed to find correlation between peak von-Mises stress/peak maximum principal strain at the cross section of the highest reduction in CSA and corresponding reduction in CSA of the cord. Dislocation and contusion showed greater peak stress and strain values in the cord than distraction. The substantial increases in von-Mises stress as well as CSA reduction similar to or more than 30% were produced at a 60% contusion and a 60% dislocation, while the maximum principal strain was gradually increased as injury severity elevated. In addition, the CSA reduction had a strong correlation with peak von-Mises stress/peak maximum principal strain for the three injury mechanisms, which might be fundamental information in elucidating the relationship between radiographic and mechanical parameters related to SCI.

Ossification of the posterior longitudinal ligament (OPLL) and ossification of the ligamentum flavum (OLF) have been recognized as causes of myelopathy due to thickening of the ligaments resulting in narrowing of the spinal canal and compression of the spinal cord. However, few studies have focused on predicting stress distribution under conditions of OPLL and OLF based on clinical aspects such as the relationship between level of stress and severity of neurologic symptoms because direct in vivo measurement of stress is very restrictive. In this study, a three-dimensional finite element model of the spinal cord in T12-L1 was developed based on MR images. The von-Mises stresses in the cord and the cross-sectional area of the cord were investigated for various grades and shapes of spinal cord compression in OPLL and OLF. Substantial increases in maximum stresses resulting in the manifestation of spinal cord symptoms occurred when the cross-sectional area was reduced by 30-40% at 60% compression of the antero-posterior diameter of the cord in OPLL and at 4mm compression in OLF. These results indicate that compression greater than these thresholds may induce spinal symptoms, which is consistent with clinical observations.

Many clinical case series have reported the predisposing factors for C5 palsy and have presented comparisons of the two types of laminoplasty. However, there have been no biomechanical studies focusing on cervical spinal cord and nerve root following laminoplasty. The purpose of this study is to investigate biomechanical changes in the spinal cord and nerve roots following the two most common types of laminoplasty, open-door and double-door laminoplasty, for cervical ossification of the posterior longitudinal ligament (OPLL). A finite element (FE) model of the cervical spine and spinal cord with nerve root complex structures was developed. Stress changes in the spinal cord and nerve roots, posterior shift of the spinal cord, and displacement of the cervical nerve roots were analyzed with two types of cervical laminoplasty models for variations in the degree of canal occupying ratio and shape of the OPLL. The shape and degree of spinal cord compression caused by the OPLL had more influence on the changes in stress, posterior shift of the spinal cord, and displacement of the nerve root than the type of laminoplasty. The lateral-type OPLL resulted in imbalanced stress on the nerve roots and the highest nerve root displacement. Type of laminoplasty and shape and degree of spinal cord compression caused by OPLL were found to influence the changes in stress and posterior displacement of the cervical spinal cord and nerve roots. Lateral-type OPLL might contribute to the development of C5 palsy due to the imbalanced stress and tension on the nerve roots after laminoplasty.