Faiz Ali

Dr. Faiz Ali

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 May 2022 in Molecules
Verified
Journal Article
Open access
PDF file
MSMaria Sadia
Maria Sadia
Izaz AhmadIzaz Ahmad
Izaz Ahmad
FAFaiz Ali
Faiz Ali
MZMuhammad Zahoor
Muhammad Zahoor
RURIAZ Ullah
RIAZ Ullah
ASAmir Sohail
Amir Sohail
A molecularly imprinting polymer (MIP) was synthesized for Basic Blue 3 dye and applied to wastewater for the adsorption of a target template. The MIPs were synthesized by bulk polymerization using methacrylic acid (MAA) and ethylene glycol dimethacrylate (EGDMA). Basic Blue 3 dye (BB-3), 2,2′-azobisisobutyronitrile (AIBN) and methanol were used as a functional monomer, cross linker, template, initiator and porogenic solvent, respectively, while non-imprinting polymers (NIP) were synthesized by the same procedure but without template molecules. The contact time was 25 min for the adsorption of BB-3 dye from 10 mL of spiked solution using 25 mg polymer. The adsorption of dye (BB-3) on the MIP followed the pseudo-second order kinetic (k2 = 0.0079 mg·g−1·min−1), and it was according to the Langmuir isotherm, with maximum adsorption capacities of 78.13, 85.4 and 99.0 mg·g−1 of the MIP at 283 K, 298 K and 313 K, respectively and 7 mg·g−1 for the NIP. The negative values of ΔG° indicate that the removal of dye by the molecularly imprinting polymer and non-imprinting polymer is spontaneous, and the positive values of ΔH° and ΔS° indicate that the process is endothermic and occurred with the increase of randomness. The selectivity of the MIP for BB-3 dye was investigated in the presence of structurally similar as well as different dyes, but the MIP showed higher selectivity than the NIP. The imprinted polymer showed 96% rebinding capacity at 313 K towards the template, and the calculated imprinted factor and Kd value were 10.73 and 2.62, respectively. In this work, the MIP showed a greater potential of selectivity for the template from wastewater relative to the closely similar compounds.

30 May 2023 in RSC Advances
Verified
Journal Article
Open access
PDF file
MKMusa Khan
Musa Khan
FAFaiz Ali
Faiz Ali
SRSaba Ramzan
Saba Ramzan
ZAZeid ALOthman
Zeid ALOthman
The sophisticatedly altered Hummer's and sol–gel procedures were applied for the synthesis of graphene oxides and porous silica monolith particles respectively. The Fischer esterification protocol was used for coupling silica monoliths with graphene oxides. A N-phenyl acrylamide-incorporated porous polymer was synthesized at the surface of composites via reversible addition fragmentation chain transfer polymerization. The composition was confirmed by Fourier transform infra-red spectroscopy, FE-SEM, X-ray diffraction, zeta potential (zeta pH), Brunauer–Emmett–Teller (BET/BJH) analysis, and EDAX analysis. The resulting polymer-bound composite efficiently removed Cr(VI) and Cr(III) from waste water. Adsorption parameters such as contact time, pH effect, temperature, and adsorbent and adsorbate concentration were optimized for the optimal output of the composite. The kinetic and equilibrium models were applied to the adsorption of Cr(VI) and Cr(III) at the adsorbent surface. The maximum adsorption capacity (qe) of Cr(VI) and Cr(III) was found to be 298.507 mg g−1 and 401.874 mg g−1, respectively, using the same initial concentration of Cr(VI) and Cr(III) [10–60 ppm]. The adsorption data of both states of the Cr-metal followed the pseudo 2nd-order kinetic model with regression values of 0.996 ∼ Cr(VI) and 0.999 ∼ Cr(III) at ambient temperature. Similarly, the adsorption data of Cr(VI) best fit into the Langmuir adsorption isotherm (R2 = 0.972) while that of Cr(III) followed the Freundlich model (R2 = 0.983).

6 September 2023 in Water
Verified
Journal Article
Open access
PDF file
MAMuhammad Ashfaq
Muhammad Ashfaq
AAAkbar Ali
Akbar Ali
Nabeel Kadhim AbboodNabeel Kadhim Abbood
Nabeel Kadhim Abbood
Sandeep PanchalSandeep Panchal
Sandeep Panchal
NANadia Akram
Nadia Akram
ANAas Nida Nazar
Aas Nida Nazar
Recently, the development of visible-light-responsive catalysts for the photodegradation of organic pollutants has captured the attention of researchers globally. The ineffectiveness and high costs associated with conventional methods and techniques used for the abatement of water pollution have forced researchers to develop effective and low-cost innovative techniques for this purpose. Photocatalysis is considered an effective protocol for this purpose. Therefore, this study was conducted for the development of the Bi2O3-NiO heterojunction as a visible-light-responsive photocatalyst for the degradation of methyl orange. Ni(NO3)2∙6H2O (Fluka) and Bi(NO3)3∙5H2O (Merck) were used as precursor materials for the synthesis of NiO-Bi2O3. After fabrication, the Bi2O3-NiO heterojunction was characterized using XRD, EDX, SEM, FTIR, and TGA techniques. Then, it was employed as a catalyst for the photodegradation of methyl orange under sunlight irradiation. The fabricated Bi2O3-NiO showed higher photocatalytic activity than Bi2O3 and NiO with 100, 67, and 46% degradation of methyl orange, respectively. The rate constant determined by the non-linear method of analysis for the photodegradation of MO in the presence of Bi2O3-NiO was 3.2-fold and 1.7-fold of the rate constant with NiO and Bi2O3, respectively. The higher photocatalytic activity of Bi2O3-NiO than of its individual components in the present study is also attributed to the separation and transfer of positive holes and electrons. The recycling of spent Bi2O3-NiO under similar experimental conditions exhibited the same photocatalytic activity suggesting the stability of the fabricated Bi2O3-NiO photocatalyst.

5 December 2022 in Scientific Reports
Verified
Journal Article
Open access
PDF file
MKMusa Khan
Musa Khan
MMMian Muhammad
Mian Muhammad
ZAZeid A. AlOthman
Zeid A. AlOthman
WCWon Jo Cheong
Won Jo Cheong
FAFaiz Ali
Faiz Ali
Highly efficient adsorbent was prepared for the removal of carbofuran and imidacloprid pesticides from wastewater. The silica monolith anchored graphene oxide composite was synthesized by the modified Fischer esterification protocol. The composite showed improved adsorption capacity for the removal of pesticides from wastewater. Graphene oxide was synthesized using the modified Hummer’s method, while the silica monolith was prepared via sol–gel method. The composite was characterized via X-ray diffraction, Fourier transform infra-red, Brunauer Emmett and Teller (BET/BJH) analysis, zeta potential, and FESEM imaging. Different adsorption parameters such as pH, contact time, adsorbate and adsorbent concentration, and temperature were optimized for the adsorption of pesticides. The equilibrium and kinetic models were applied to the adsorption process of the pesticides. Qe of the composite as found to be 342.46 mg g−1 for imidacloprid and 37.15 mg g−1 for carbofuran. The adsorption process followed the pseudo 2nd order kinetic model for carbofuran (R2~0.9971) and imidacloprid (R2~0.9967). The Freundlich isotherm best fitted to the adsorption data of the pesticides with R2 value of 0.9956 for carbofuran and 0.95 for imidacloprid. The resultant adsorbent/composite material came out with very good results for the removal of pesticides.

29 June 2022 in RSC Advances
Verified
Journal Article
Open access
PDF file
FAFaiz Ali
Faiz Ali
ZSZuber Shah
Zuber Shah
AKAlamgir Khan
Alamgir Khan
MSMaria Saadia
Maria Saadia
ZAZeid ALOthman
Zeid ALOthman
WCWon Jo Cheong
Won Jo Cheong
MIP synthesis for the recently emerging dyes, a new method for their characterization in liquid chromatography by packing packing the MIP particles in a stainless steel column, and their application in environmental remediation.

25 January 2021 in Journal of Separation Science
Verified
Journal Article
Closed access
PDF file
FAFaiz Ali
Faiz Ali
WCWon Jo Cheong
Won Jo Cheong
ARAamra Rafique
Aamra Rafique
ZAZeid A. AlOthman
Zeid A. AlOthman
MSMaria Sadia
Maria Sadia
MMMian Muhammad
Mian Muhammad