Understanding the time-dependent deformation behaviour of backfill coral sand is important to the long-term stability of engineering facilities built on reefs and reclaimed land. A series of one-dimensional compression tests (with no lateral strain) were carried out on crushed coral sand with a variety of grading and relative densities (50%, 70%, and 90%) sampled from the South China Sea. Axial pressure was applied in stepped loading form: 100, 200, 400, 800, and 1600 kPa. Each level loading was applied for 3 days and then completely unloaded until the deformation was stable, after which the next loading level was applied. The test results indicate: (i) the deformation of coral sand is much larger than silica sand and involves a larger proportion of time-dependent and plastic deformation; (ii) the total deformation of coral sand and proportion of irreversible deformation decreases as the relative density increases; (iii) coral sands of better grading tend to deform less in total and have larger proportions of elastic and time-dependent deformation; and (iv) the grading of coral sand changes during the deformation process due to particle breakage. Based on the test results, the relationships between particle breakage and pressure, relative density, and grading, as well as the grain-scale mechanism of the deformation, are discussed.
Poisson’s ratio is of crucial importance for the theoretical and numerical analysis of rock engineering. It is an elastic parameter of the material and the ratio of the absolute value of lateral strain and axial strain when the material is under uniaxial tension or compression. However, it was rarely investigated compared with deformation modulus and strength. Rock materials are different from metal materials. The pure elastic deformation stage is usually very short or nonexistent in the process of uniaxial tension or compression. In this paper, in order to explore the behavior of Poisson’s ratio, uniaxial compression tests according to The International Society for Rock Mechanics and Rock Engineering are performed on standard specimens of granite, marble, red sandstone, carbonate rock, coral concrete, etc. According to the results, Poisson’s ratio, both the secant Poisson’s ratio and tangent Poisson’s ratio, increase with the externally applied stress. Therefore, regarding it as an elastic constant is worthy of a second thought. If the midpoint of the stress interval is fixed in the 50% of uniaxial compressive strength, the average Poisson’s ratio is almost impervious to the varying span of the stress interval. In addition, the average Poisson’s ratio is immune to the nonlinear deformation in the early loading stage. Thus, the average Poisson’s ratio is a better index than the secant Poisson’s ratio in describing the relationship between axial and lateral strains of hard rocks. The determination of Poisson’s ratio of soft rocks needs further investigation because Poisson’s ratio tends to exceed the theoretical limit in relatively low stress levels. The proposed viewpoint provides a deeper insight into the testing, determining, and using of Poisson’s ratio.
14 March 2026 in International Journal of Mining Science and Technology
An improved attribute recognition method is reviewed and discussed to evaluate the risk of water inrush in karst tunnels. Due to the complex geology and hydrogeology, the methodology discusses the uncertainties related to the evaluation index and attribute measure. The uncertainties can be described by probability distributions. The values of evaluation index and attribute measure were employed through random numbers generated by Monte Carlo simulations and an attribute measure belt was chosen instead of the linearity attribute measure function. Considering the uncertainties of evaluation index and attribute measure, the probability distributions of four risk grades are calculated using random numbers generated by Monte Carlo simulation. According to the probability distribution, the risk level can be analyzed under different confidence coefficients. The method improvement is more accurate and feasible compared with the results derived from the attribute recognition model. Finally, the improved attribute recognition method was applied and verified in Longmenshan tunnel in China.