Growing global water demand has brought desalination technologies to the forefront for freshwater production from nontraditional water sources. Among these, forward osmosis (FO) is a promising two-step desalination process (draw dilution and regeneration), but it is often overlooked due to the energy requirements associated with draw regeneration. To address this limiting factor, we demonstrate FO desalination using thermally responsive ionic liquids (ILs) that are regenerated using a renewable energy input, that is, solar heat. To efficiently harness sunlight, a simple photonic heater converts incoming irradiation into infrared wavelengths that are directly absorbed by IL–water mixtures, thereby inducing phase separation to yield clean water. This approach is markedly different as it uses radiative heating, a noncontact mode of heat transfer that couples to chemical functional groups within the IL for rapid energy transfer without a heat exchanger or secondary fluid. Overall, a solar-thermal separation efficiency of 50% is achieved under unconcentrated sunlight, which can be increased to 69% with the thermal design. Successful desalination of produced water from oil wells in Southern California highlights the potential of solar-powered IL-FO for energy-efficient and low-cost desalination of complex brines for beneficial water reuse.
6 June 2025 in Resources, Conservation and Recycling
All solid-state batteries (SSBs) are considered the most promising path to enabling higher energy-density portable energy, while concurrently improving safety as compared to current liquid electrolyte solutions. However, the desire for high energy necessitates the choice of high-voltage cathodes, such as nickel-rich layered oxides, where degradation phenomena related to oxygen loss and structural densification at the cathode surface are known to significantly compromise the cycle and thermal stability. In this work, we show, for the first time, that even in an SSB, and when protected by an intact amorphous coating, the LiNi0.5Mn0.3Co0.2O2 (NMC532) surface transforms from a layered structure into a rocksalt-like structure after electrochemical cycling. The transformation of the surface structure of the Li3B11O18 (LBO)-coated NMC532 cathode in a thiophosphate-based solid-state cell is characterized by high-resolution complementary electron microscopy techniques and electron energy loss spectroscopy. Ab initio molecular dynamics corroborate facile transport of O2- in the LBO coating and in other typical coating materials. This work identifies that oxygen loss remains a formidable challenge and barrier to long-cycle life high-energy storage, even in SSBs with durable, amorphous cathode coatings, and directs attention to considering oxygen permeability as an important new design criteria for coating materials.
20 November 2024 in Journal of Materials Chemistry A
Mixtures of two thermally responsive ionic liquids (ILs) in water exhibiting phase separation above a lower critical solution temperature (LCST) demonstrate a synergy that enhances the osmotic strength and lowers the LCST compared to binary mixtures.