We report results of Brillouin—Mandelstam spectroscopy of transparent Al2O3 crystals with Nd dopants. The ionic radius and atomic mass of Nd atoms are distinctively different from those of the host Al atoms. Our results show that even a small concentration of Nd atoms incorporated into the Al2O3 samples produces a profound change in the acoustic phonon spectrum. The velocity of the transverse acoustic phonons decreases by ∼600 m/s at the Nd density of only ∼0.1%. Interestingly, the decrease in the phonon frequency and velocity with the doping concentration is non-monotonic. The obtained results, demonstrating that modification of the acoustic phonon spectrum can be achieved not only by traditional nanostructuring but also by low-concentration doping, have important implications for thermal management as well as thermoelectric and optoelectronic devices.
Here, we develop and characterize high thermal conductivity/high thermal shock-resistant bulk Ce-doped Al2O3 and propose it as a new phosphor converting capping layer for high-powered/high-brightness solid-state white lighting (SSWL). The bulk, dense Ce:Al2O3 ceramics have a 0.5 at.% Ce:Al concentration (significantly higher than the equilibrium solubility limit) and were produced using a simultaneous solid-state reactive current activated pressure-assisted densification (CAPAD) approach. Ce:Al2O3 exhibits a broadband emission from 400 to 600 nm, which encompasses the entire blue and green portions of the visible spectrum when pumped with ultraviolet (UV) light that is now commercially available in UV light–emitting devices and laser diodes (LD). These broadband phosphors can be used in the commonly used scheme of mixing with other UV-converting capping layers that emit red light to produce white light. Alternatively, they can be used in a novel composite down-converter approach that ensures improved thermal–mechanical properties of the converting phosphor capping layer. In this configuration, Ce:Al2O3 is used with proven phosphor conversion materials such as Ce:YAG as an active encapsulant or as a capping layer to produce SSWL with an improved bandwidth in the blue portion of the visible spectrum. To study the effect of crystallinity on the Ce photoluminescent (PL) emission, we synthesize Ce:YAG ceramics using high-pressure CAPAD at moderate temperatures to obtain varying crystallinity (amorphous through fully crystalline). We investigate the PL characteristics of Ce:Al2O3 and Ce:YAG from 295 to 4 K, revealing unique crystal field effects from the matrix on the Ce dopants. The unique PL properties in conjunction with the superior thermal–mechanical properties of Ce:Al2O3 can be used in high-powered/high-brightness–integrated devices based on high-efficiency UV-LD that do not suffer efficiency droop at high drive currents to pump the solid-state capping phosphors.
Producing bulk AlN with grain sizes in the nano regime and measuring its thermal conductivity is an important milestone in the development of materials for high energy optical applications. We present the synthesis and subsequent densification of nano-AlN powder to produce bulk nanocrystalline AlN. The nanopowder is synthesized by converting transition alumina (δ-Al2O3) with <40 nm grain size to AlN using a carbon free reduction/nitridation process. We consolidated the nano-AlN powder using current activated pressure assisted densification (CAPAD) and achieved a relative density of 98% at 1300 °C with average grain size, ~125 nm. By contrast, high quality commercially available AlN powder yields densities ~75% under the same CAPAD conditions. We used the 3-ω method to measure the thermal conductivity, κ of two nanocrystalline samples, 91% dense, = 110 nm and 99% dense, = 220 nm, respectively. The dense sample with 220 nm grains has a measured κ = 43 W/(m·K) at room temperature, which is relatively high for a nanocrystalline ceramic, but still low compared to single crystal and large grain sized polycrystalline AlN which can exceed 300 W/(m·K). The reduction in κ in both samples is understood as a combination of grain boundary scattering and porosity effects. We believe that these are finest reported in bulk dense AlN and is the first report of thermal conductivity for AlN with ≤220 nm grain size. The obtained κ values are higher than the vast majority of conventional optical materials, demonstrating the advantage of AlN for high-energy optical applications.
We report results of Brillouin - Mandelstam spectroscopy of transparent alumina crystals with Nd dopants. The ionic radius and atomic mass of Nd atoms are distinctively different from those of the host Al atoms. Our results show that even a small concentration of Nd atoms incorporated into the alumina samples produces a profound change in the acoustic phonon spectrum. The velocity of the transverse acoustic phonons decreases by ~600 m/s at the Nd density of only ~0.1 %. Interestingly, the decrease in the phonon frequency and velocity with the doping concentration is non-monotonic. The obtained results, demonstrating that modification of the acoustic phonon spectrum can be achieved not only by nanostructuring but also by doping have important implications for thermal management as well as thermoelectric and optoelectronic devices.