Multi-core–shell Li6PS5Cl@LiNbO3@LiNi0.8Mn0.1Co0.1O2 composite cathode can achieve high capacity, high rate, and long cycle-life sulfide based all-solid-state lithium batteries (ASSLBs).
3 November 2022 in Journal of Materials Chemistry A
Practical All-Solid-State Li-Ion Batteries (ASSLBs) require small-sized sulphide solid electrolyte (SSE) particles (SSE membranes (few microns) and composite electrodes (sub-microns)). However, particle-size reduction via mechanical crushing and classification significantly reduces the crystallinity and Li-ion conductivity of SSEs. Here, we introduce a novel facile polar-to-nonpolar solvent exchange technique, wherein an SSE-dissolved polar solvent (e.g., Li6PS5Cl in ethanol) is injected into a heated nonpolar solvent (e.g., n-decane at 100 °C), leading to instantaneous volume-confined recrystallisation. Using this method, the particle size can be easily controlled by adjusting the process parameters. The average particle size of the solvent-exchanged commercial Li6PS5Cl SSE decreases from 8 to 0.88 μm, while a Li-ion conductivity of 1.54 mS cm−1 (∼85% vs. pristine Li6PS5Cl) is retained after annealing at 550 °C. The sub-micron SSE particles, incorporated into a composite cathode with Li(Ni0.8Co0.1Mn0.1)O2, improve the utilisation and interfacial robustness of the active material. The initial discharge capacity of the ASSLB increases from 179 to 197 mA h g−1 at 0.05C, and the capacity retention improves from 79% to 85% after 50 cycles at 0.1C and 55 °C. Thus, the solvent exchange approach may open new pathways for the synthesis of size-controlled high-quality SSEs for ASSLBs.
Vertically aligned Fe, S, and Fe-S doped anatase TiO2 nanotube arrays are prepared by an electrochemical anodization process using an organic electrolyte in which lactic acid is added as an additive. In the electrolyte, highly ordered TiO2 nanotube layers with greater thickness of 12 μm, inner diameter of approx. 90 nm and outer diameter of approx. 170 nm are successfully obtained. Doping of Fe, S, and Fe-S via simple wet impregnation method substituted Ti and O sites with Fe and S, which leads to enhance the rate performance at high discharge C-rates. Discharge capacities of TiO2 tubes increased from 0.13 mAh cm−2(bare) to 0.28 mAh cm−2 for Fe-S doped TiO2 at 0.5 C after 100 cycles with exceptional capacity retention of 85 % after 100 cycles. Owing to the enhancement of thermodynamic and kinetic properties by doping of Fe-S, Li-diffusion increased resulting in remarkable discharge capacities of 0.27 mAh cm−2 and 0.16 mAh cm−2 at 10 C, and 30 C, respectively.