Potato starch wastewater, a byproduct of potato processing, is an escalating environmental concern due to its high concentrations of COD (chemical oxygen demand), ammonia nitrogen, and total phosphorus (TP). Addressing this challenge, this research introduced a novel method combining chitosan-modified biochar film (CBC) adsorption with subsequent ultrafiltration. SEM (scanning electron microscope), FTIR (Fourier transform infrared spectral), XRD (X-ray diffractometer), and BET (specific surface area) analyses validated CBC’s enhanced surface characteristics, confirming successful chitosan (CS) film impregnation. CBC exhibited superior adsorption capacities, especially 40%wt-CBC, optimizing COD removal at 79.8%, ammonia nitrogen at 93.3%, and TP at 91.2%. Kinetic studies associated the adsorption process with a pseudo-second-order model, highlighting chemical adsorption. Additionally, the Langmuir isotherm model suggested monolayer adsorption with no inter-adsorbate interactions. The treated effluent, post adsorption, was directed through an ultrafiltration membrane, ensuring water quality suitable for reuse. This integrative treatment not only offers an effective solution for potato starch wastewater management but also underscores the potential for sustainable water resource recovery in the food processing sector.

Herein, a chitosan film (CS) was modified using 2,3-epoxy-propyl trimethyl ammonium chloride (GTA) to flocculate granular pollutants in potato starch wastewater, aiming at the deficiencies of poor water solubility and weak electropositivity of the chitosan film. By examining the degree of substitution of chitosan film amino under different factors and different levels and response surface optimization tests, the optimum preparation conditions of chitosan film quaternary ammonium salt (HTCC) were obtained. Using scanning electron microscopy (SEM), Fourier infrared (FTIR) spectroscopy, X-ray diffraction (XRD), and ¹H-nuclear magnetic spectroscopy, the nucleophilic substitution reaction of the GTA molecule with the hydrogen atoms in the chitosan film amino group successfully improved the water solubility and electropositivity of the chitosan film. HTCC was used to treat potato starch wastewater, and the optimal flocculation conditions were obtained. The flocculation product was recovered, and the composition analysis of the flocculation product demonstrated that HTCC-potato protein flocculation precipitate was rich in high protein, which is a good choice of feed and can realize sustainable utilization of resources.

In this paper, reduced graphene oxide (RGO) was prepared by a modified Hummers method and chemical reduction method, and an RGO/TiO₂ NTs (RGO/TiO₂ nanotubes) photoelectrode was prepared by the electrochemical deposition method. The as-prepared RGO/TiO₂ NTs were analyzed by scanning electron microscopy (SEM) and X-ray diffraction (XRD), and their photocatalytic activities were investigated by measuring the degradation of methylene blue (MB) under simulated solar light irradiation. The SEM and XRD results indicated that the original tubular structure of TiO₂-NTs was not changed after RGO modification. The surface of the TiO₂ NTs photoelectrode was covered with a non-uniform, flake-shaped reduced graphene oxide film. The thickness of the RGO/TiO₂ NTs was increased to about 22.60 nm. The impedance of the RGO/TiO₂ NTs was smaller than that of the TiO₂ NT photoelectrode. The optimal preparation conditions of RGO/TiO₂ NT photoelectrodes were investigated by using a single factor method and response surface method. The best preparation conditions were as follows: deposition potential at 1.19 V, deposition time of 10.27 min, and deposition temperature at 24.94 °C.