For detection of cannabidiol (CBD)—an important ingredient in Cannabis sativa L.—amino magnetic nanoparticle-decorated graphene (Fe₃O₄-NH₂-GN) was prepared in the form of nanocomposites, and then modified on a glassy carbon electrode (GCE), resulting in a novel electrochemical sensor (Fe₃O₄-NH₂-GN/GCE). The applied Fe₃O₄-NH₂ nanoparticles and GN exhibited typical structures and intended surface groups through characterizations via transmission electron microscopy (TEM), scanning electron microscopy (SEM), X-ray powder diffraction (XRD), vibrating sample magnetometer (VSM), and Raman spectroscopy. The Fe₃O₄-NH₂-GN/GCE showed the maximum electrochemical signal for CBD during the comparison of fabricated components via the cyclic voltammetry method, and was systematically investigated in the composition and treatment of components, pH, scan rate, and quantitative analysis ability. Under optimal conditions, the Fe₃O₄-NH₂-GN/GCE exhibited a good detection limit (0.04 μmol L⁻¹) with a linear range of 0.1 μmol L⁻¹ to 100 μmol L⁻¹ (r² = 0.984). In the detection of CBD in the extract of C. sativa leaves, the results of the electrochemical method using the Fe₃O₄-NH₂-GN/GCE were in good agreement with those of the HPLC method. Based on these findings, the proposed sensor could be further developed for the portable and rapid detection of natural active compounds in the food, agricultural, and pharmaceutical fields.

The discovery of a green extraction solvent for natural plants could promote related research. In this study, deep eutectic solvents (DES) were used as green solvents coupled with an ultrasound-assisted extraction method (UAE) to extract flavonoids from lotus leaves. Thirty-four different DES were performed and choline chloride/urea with 40% water was chosen as the most promising one, and the related parameters in the procedures were optimized, resulting in the highest extraction amount of flavonoids in lotus leaves. D-101 was selected from four macroporous resins to separate the flavonoids from DES. Moreover, DES could be recycled and efficiently reused four times with satisfactory performances. In addition, the lotus leaf flavonoids from the DES extract exhibited antioxidant activities in five kinds of assays including DPPH, ABTS, Fe³⁺ reducing, FRAP, and Fe²⁺ chelating. It also showed antibacterial activities on Staphylococcus aureus and Escherichia coli bacterial strains with minimal inhibitory concentrations at 1666 μg/mL and 208 μg/mL, respectively. In the HPLC analysis, the three main components in the DES extract were identified as astragalin, hyperoside, and isoquercitrin. In conclusion, the developed UAE-DES followed by macroporous resin treatment could become an efficient and environmentally friendly extraction and enrichment method for flavonoids from lotus leaves and other natural products.

Olivetol is an important polyphenol compound and intermediate in the synthesis of cannabinoids possessing many types of biological activities. A facile electrochemical sensor for olivetol was fabricated based on p-L-serine, and copper oxide (CuO) nanoparticles modified carbon paste electrode (p-L-serine/CuO/CPE). The proposed p-L-serine/CuO/CPE was applied to the electrochemical detection of olivetol by cyclic voltammetry (CV) and differential pulse voltammetric (DPV). Through the characterizations of materials and modified electrodes, the p-L-serine/CuO/CPE exhibited enhanced electrochemical signals for olivetol compared to bare CPE and CuO/CPE in both CV and DPV methods. Under the optimized conditions, the proposed p-L-serine/CuO/CPE showed a good quantitative analysis ability and a wide analysis range from 20 to 100 μmol L⁻¹ of olivetol with a limit of detection of 1.04 μmol L⁻¹. Based on the reproducibility, repeatability, and stability exhibited by this fabricated sensor and the cheap and accessible raw materials, the p-L-serine/CuO/CPE became a novel determination choice for olivetol in the electrochemical method with the advantages of being cost-effective and convenient.