This paper analyzes the performance of multi-user full-duplex (FD) massive multiple-input multiple-output (MIMO) systems with low resolution analog-to-digital converters (ADCs) and digital-to-analog converters (DACs) under Rician fading channels. The maximum ratio combining (MRC) and maximum ratio transmission (MRT) are used at the base station (BS) for the uplink and downlink, respectively. By leveraging on the additive quantization noise model (AQNM), tight closed-form approximations of the uplink and downlink achievable rates are obtained for both perfect and imperfect channel state information (CSI) cases. The results show the impact of the Rician K- factor, ADC/DAC resolution, loop interference (LI), and interuser interference (IUI) of the systems. In addition, we adopt the power scaling law to show that to achieve a fixed level of the signal-to-interference-plus-noise ratio (SINR), the transmit power of each user and the BS can be scaled down proportionally to the inverse of the BS antenna number. Moreover, we compare the performance of the FD mode and the half-duplex (HD) mode, and study the trade-off between achievable rate and BS energy efficiency. Numerical results show that the use of low-resolution ADCs/DACs can significantly improve the BS energy efficiency with only small reduction in the achievable rate of the FD system.
16 October 2017 in IEEE Transactions on Vehicular Technology
This paper considers the uplink of multi-user massive multi-input multi-output (MIMO) systems with a mixed analog-to-digital converter (ADC) architecture, in which the base station (BS) is equipped with ADCs of different resolution levels. While higher resolution ADCs reduce the quantization error to improve the performance, they also incur higher energy. This paper studies the receive energy efficiency (EE) and the ADC resolution profile design under the maximum-ratio combining (MRC) receiver. First, closed-form approximations for the SE and receive EE are derived for a general mixed ADC structure. Then the ADC resolution profile optimization problem that maximizes the receive EE with respect to SE requirement is formulated. An algorithm based on decremental searching and dynamic programming is proposed whose complexity is linear in the number of BS antennas. Numerical results verify that with the proposed design, the mixed-ADCs receiver can have nearly the same SE performance as the all full-resolution one but with considerably lighter burden of energy consumption.
31 July 2018 in IEEE Transactions on Wireless Communications
This paper analyzes the outage probability for the uplink of multi-user massive multi-input-multi-output systems with a mixed analog-to-digital converter (ADC) architecture, in which the base station (BS) is equipped with ADCs of different resolution levels. Maximum-ratio combining (MRC) is used at the BS. By deriving the distribution of the user-interference power and statistical properties of other components in the signal-to-interference-plus-noise-ratio (SINR), a tight closed-form approximation for the outage probability is obtained for a general mixed ADC structure with any resolution profile. Then, two methods for the ADC resolution profile optimization are proposed considering both the outage probability and the BS energy consumption. The first method uses low-complexity incremental search to minimize the BS energy consumption for given outage probability constraint. The other method is based on multi-objective optimization and adopts a discrete-variation of the classic non-dominated sorting genetic algorithm II (NSGA-II). Numerical results are presented to validate the outage probability results. Furthermore, it is shown that the two proposed mixed-resolution ADC designs largely outperform a two-level ADC structure and provide more choices than the uniform ADC structure for resolving the tradeoff between outage probability and BS energy consumption.
In this paper, we investigate the spectral efficiency (SE) and energy efficiency (EE) of hybrid precoding in the point-to-point mmWave massive multiple-input multiple-output (MIMO) system with lowresolution analog-to-digital converters (ADCs) and digital-to-analog converters (DACs). First, considering the quantization noise of ADCs/DACs, an approximation expression for the SE is derived. Then, in order to solve the problem of non-convex hybrid precoding design, based on the derived analytical approximation expression, we propose a two-stage alternating minimization scheme to obtain the optimal hybrid precoder matrix. And the trade-offs between SE and EE with the full digital precoding and hybrid precoding are investigated. Numerical results verify that the system with the proposed scheme has nearly the same SE performance as with the full digital precoding. The fully connected hybrid precoding can be more energyefficient compared to the full digital precoding, and the proposed hybrid precoding scheme can achieve the better trade-off between the SE and EE. Moreover, the increase in the resolution of ADCs/DACs can effectively improve the SE performance of the system, and 4-bits ADCs/DACs achieve the best EE performance for the hybrid precoding.
6 December 2019 in IEEE Wireless Communications Letters
This letter is on the multi-user massive multi-input multi-output (MIMO) uplink with the mixed analog-to-digital converter (ADC) architecture and the zero-forcing (ZF) receiver at the base station (BS). Under imperfect channel state information (CSI), a closed-form approximation of the spectral efficiency (SE) is derived for a general resolution profile. Further, simplified SE results are provided for two common asymptotic massive MIMO scenarios. In the SE analysis, to overcome the difficulty induced by the mixed-ADC structure, new techniques are developed in calculating the average noise powers caused by the CSI error and the quantization.
In this paper, a collaborative power line communication (PLC) and generalized spatial modulation architecture (CPGA) is proposed to resolve the adaptive secure transmission problem in smart grid. In the proposed CPGA, the adaptive transmission is driven by the level of data in smart grid, which is achieved through a proposed antenna selection scheme based on interval quantification. And the anti-eavesdropping ability is improved through PLC-assisted transmission and the artificially designed jammer. Additionally, a better management ability of energy efficiency is guaranteed based on the data-driven adaptive transmission scheme. The closed-form expressions of the security capacity, the management ability of energy efficiency and average bit error rate (ABER) are derived for the performance of adaptive secure transmission. Finally, we analyze the security capacity, management capability of energy efficiency and ABER of the CPGA. Numerical results show that better ABER performance can be achieved in the CPAG compared with the traditional GenSM. Moreover, for the traditional multi-input multi-output, the better security capacity and management of energy efficiency can be achieved in the CPGA. And the adaptive balance between secure level and energy management are realized through the CPGA in smart grid.