A significant amount of waste cooking oil (WCO) remains in the food preparation process worldwide on a daily basis, which can cause environmental pollution if disposed of improperly. The cheapest and effective way to dispose of WCO is by blending it with diesel fuel. In this study three various blends of WCO and diesel fuel were prepared with a WCO proportion of 10%, 20% and 30% and properties were evaluated and compared with petroleum diesel fuel. The density and dynamic viscosity of the blend increase with the increase in WCO content, while the heating value decreases. The blends were then tested in tractor direct injection diesel engine to determine the effect of blending WCO with diesel fuel on the engine performances (power, torque and fuel consumption) and exhaust gases emission (CO, CO2, HC and NOx). The results show that the engine performances using WCO blends are comparable to petroleum diesel fuel and a blend with 30% WCO (B30) achieved the best results among the fuel blends. There were no significant differences in average engine power, torque and fuel consumption per hour between petroleum diesel fuel and B30 blend, while significantly lower (P˂0.05) average specific fuel consumption were achieved using diesel fuel. The significantly lower (P˂0.05) average CO and CO2 emissions and significantly higher (P˂0.05) average HC emission was achieved using diesel fuel compared to B30 blend. No significant difference in average NOx emission was observed between diesel fuel and B30 blend.
1 December 2019 in Die Bodenkultur: Journal of Land Management, Food and Environment
Summary: Industrial revolution and modernization of agriculture in Croatia and Slavonia began in mid-19 th century and evolved at a slower pace compared to the other countries of the Austrian Empire. The main reasons were lack of capital, shortage of good river- and land traffic routes, slowness in the construction of railways, slowness in the introduction of steam engines, lack of skilled workforce and extensive farming. The second agricultural crisis in Europe, which lasted from 1873 until 1895, motivated large holdings in Croatia and Slavonia to introduce steam engines and machines for the purpose of rationalization of agricultural production. Locomobiles were mostly represented on holdings with over 575.5 ha. The then country of Slavonia, as an eminently agrarian region and the main source of wheat was leader in the use of steam engines, steam ploughs and steam-powered machines in agriculture. The locomobile was used in agriculture until the mid-20 th century and was discontinued with the growing use of tractors with internal combustion engine and the use of combine harvesters. Until 1918, Croatian lands were a part of the Austro-Hungarian Monarchy.
This study evaluated the effects of different mechanical weed control systems on weed biomass, weed flora composition and maize grain yield during a three-year field experiment conducted from 2021 to 2023 in the Zagreb area, Croatia, using a randomized complete block design with three replications. The following three weed control treatments were compared. T1—mechanical weed control between the crop rows with a motor cultivator combined with manual hoeing within the crop rows. T2—mechanical weed control between the crop rows with a motor cultivator without weed control within the crop rows. T3—without any weed control as control. The weed control system had a statistically significant effect (p < 0.001) on weed biomass and maize grain yield throughout the study. The lowest average weed biomass and the highest average grain yield were recorded in T1, whereas the untreated control (T3) had the highest weed biomass and the lowest grain yield. Regression analysis indicated a strong negative association between weed biomass and maize grain yield (R2 = 0.833), demonstrating that higher weed biomass was associated with lower grain yield. During the three-year experiment, 14 weed species were recorded, with Amaranthus retroflexus, Ambrosia artemisiifolia, Sorghum halepense and Chenopodium album being the dominant species. The results indicate that combining mechanical weed control between the crop rows with manual hoeing within the crop rows was the most effective weed control strategy under the conditions of this study.
Umjetna inteligencija (AI) i strojno učenje (ML ) sve su prisutniji u poljoprivrednom sektoru pa tako i u proizvodnji krmnih smjesa, gdje omogućuju proizvođačima optimizaciju procesa proizvodnje, smanjenje troškova i poboljšanje učinkovitosti. Implem...