BCR methods are known for leaching of heavy metals in sediment material. However, there is no optimization of modification BCR using a microwave in Fe in the Gulf of Prigi sediment. Thus in this paper, we attempted to use the variation of modified microwave power (10%, 25%, 50% watt) followed with contact time ranges (from 1 to 3 minutes). The results showed the fast method of BCR for leached Fe using a microwave with an optimized condition in the fraction 1 and fraction 2 with 50% watt at 2 minutes, fraction 3 (10% watt at 2 minutes) and fraction 4 (temperature used at 185 degrees Celsius at 10 minutes) in sediment materials. These investigated were also supported by characterization using SEM EDAX and AAS measurements of Fe in the filtrate sediment.
1 September 2018 in Journal of Physics: Conference Series
The changes in the aquatic environment by either natural or anthropogenic sources may affect the presence of heavy metals in the sediment of Sendang Biru Port. Heavy metals such as Fe, Ni, and Mn possibly give a negative impact on ecological and biological systems in the sea water. To monitor the status of sediment of the Port Sendang Biru, we investigated the geochemical fraction of Fe, Ni, and Mn in sediment using the BCR (European Community Bureau of Reference) sequential leaching method. The precision test of BCR method showed that Fe, Ni, and Mn has 4.82; 3.73; and 3.16 Relative Standard Deviation (RSD), respectively. The accuracy test of BCR method showed that percentage recovery for Fe, Ni, and Mn were 85.5%; 96.2%; and 63.0%, respectively. The fractionation of Fe, Ni, and Mn in the sediment of Sendang Biru Port showed that Fe was dominant in residual fraction (90.7%), whereas Ni and Mn were dominant in non-residual fraction (78.8% Ni and 77.2% Mn). The dominance of Fe in the residual fraction indicated that Fe was from natural sediment minerals bound to silicate and aluminate, whereas the dominance of Ni and Mn in non-residual fractions was possibly derived from anthropogenic effects. Assessment from index calculation of sediment had the category contaminated at moderate levels by Ni and contaminated at low levels by Fe and Mn.
1 September 2018 in Journal of Physics: Conference Series
The high presence of heavy metals in sediment can affect the ecological and biological systems in East Java Indonesia. To monitor the environmental status of Fe and Mn, we investigated geochemical fraction and distribution of these metals at 8 sites in the sediment of Sendang Biru. BCR and Tessier sequential leaching methods were applied to leach Fe and Mn, respectively, due to high precision and accuracy of these methods. The pattern of geochemical fractions in sediment samples showed the maximum leached levels of Fe and Mn (>50%) in residual fractions in Sendang Biru Beach, indicating the natural effects surrounding sites. The portions of Fe and Mn in non-residual fractions located at Sendang Biru Port were higher compared with the site in the adjacent sea, indicating these metals were derived possibly from anthropogenic effects. The assessment from CF and Igeo calculations of Fe and Mn in sediment samples showed that the sediment near the Sendang Biru Port was moderately contaminated by Fe and Mn.
17 April 2019 in IOP Conference Series: Materials Science and Engineering
Uncontrolled urbanization and growing industrialization are major sources of pollutants that affect the urban stormwater quality and, therefore, the receiving aquatic environment. The concentrations of heavy metals (As, Cd, Cr, Cu, Fe, Ni, Pb, and Zn), and Pb isotope ratios in surface sediment samples obtained from SMART holding and storage ponds located in Kuala Lumpur were investigated using inductively coupled plasma-mass spectrometry (ICP-MS). The highest metal concentrations were found at the SMART holding pond (SHP), the first recipient of urban stormwater runoff from the SMART system catchment area. As, Cd, Pb, and Zn are the dominant metal contaminants in the sediments of both SMART ponds, with values exceeding the average shale values. According to contamination indices applied to evaluate the environmental risk caused by heavy metals, As had the highest values among the metals examined, denoting moderate contamination. Hence, it can frequently cause harmful effects on the sediment-living species. The Pb isotope ratios (206Pb/207Pb and 208Pb/207Pb) indicated that coal combustion was the foremost source of anthropogenic Pb in the sediments of both SMART ponds. The control of coal combustion and sites undergoing intensive human activities should be given priority in the foreseeable future.