Time-resolved studies of silylene, SiH2, generated by laser flash photolysis of phenylsilane, have been carried out to obtain rate constants for its bimolecular reaction with C2D4. The reaction was studied in the gas phase, over the pressure range 1–100 Torr (in SF6 bath gas) at five temperatures in the range 291–595 K. The reaction of SiH2 + C2D4 was pressure dependent but significantly less so than that of SiH2 + C2H4 studied earlier. The high pressure limiting rate constants were the same for the two reaction systems within experimental error. RRKM modelling studies were carried out but the calculated inverse isotope effects, kD/kH, were poorly reproduced by a mechanism consisting of a simple third body assisted association reaction. When this was extended to include a reversible isotopic scrambling process, the RRKM modelling of the isotope effects gave better agreement with experiment, although not perfect agreement with the pressure dependence. This mechanism, involving the reversible isomerisation of silirane-d4 to ethylsilylene-d4, is consistent with thermochemical and ab initio calculations of the energy surface.
Corrosion processes are accountable for serious losses in the oil industry. Although organic and inorganic materials and mixed materials inhibitors have been used for a long time to control or reduce corrosion. Using nano-materials as inhibitors has gained an increasing applications role because of their exceptional properties. Nano materials are good corrosion inhibitors because they possess many advantages such as high efficiency of inhibition, low cost, minimum toxicity and effortless production. This work examines the use of nano-materials as inhibitors to prevent corrosion of carbon steel in drilling mud. Anti-corrosion properties of zinc and nickel ferrite nano materials (ZnFe2O4, Zn0.6Ni0.4Fe2O4) have been investigated over carbon steel in local Iraqi bentonite mud as a source of the corrosion. It has been found that under the given conditions, ferrites act as efficient corrosion inhibitors of carbon steel.
The technology of ultrasound has been found to be suitable for water and wastewater remediation as one of the advanced oxidation process. Power ultrasound, as an emerging green technology has received increasing attention of the petroleum industry. The physical and chemical effects of the periodic oscillation and implosion of acoustic cavitation bubbles can be employed to perform a variety of functions. This knowledge has been utilized in the degradation of organic constituents during the cavitation procedure of ultrasound waves. The occurrence of cavitation would give upsurge to a number of interesting physical and chemical special effects to segregate and oxidize pollutants in water/wastewater. Ultrasounds pledge scattering and emulsification of matters giving to the effect of coagulation and degassing, impacting the crystallization and dissolution processes. It has been well-known that ultrasound could cause a diversity of chemical changes of the constituents, this comprises of oxidation, reduction, dissolution, polymerization etc. The elucidation of these behavior is realized in a range of effects such as cavitation, micro-flows, shock waves, acoustic wind etc. In this reviewing paper, previous research concerning the optimization of ultrasonic decomposition of water/wastewater remediation systems in particular for oily wastewater are wisely reviewed. The basic principles of ultrasound and cavitation are presented, and the consequence of influencing parameters on the decay reactions comprising the ultrasonic power, frequency, dissolved gases, and targeted constituents are revised and discussed.