This paper presents the non-uniform change in cell thickness of cylindrical Lithium (Li)-ion cells due to the change of State of Charge (SoC). Using optical measurement methods, with the aid of a laser light band micrometer, the expansion and contraction are determined over a complete charge and discharge cycle. The cell is rotated around its own axis by an angle of in each step, so that the different positions can be compared with each other over the circumference. The experimental data show that, contrary to the assumption based on the physical properties of electrode growth due to lithium intercalation in the graphite, the cell does not expand uniformly. Depending on the position and orientation of the cell coil, there are different zones of expansion and contraction. In order to confirm the non-uniform expansion around the circumference of the cell in 3D, X-ray computed tomography (CT) scans of the cells are performed at low and at high SoC. Comparison of the high resolution 3D reconstructed volumes clearly visualizes a sinusoidal pattern for non-uniform expansion. From the 3D volume, it can be confirmed that the thickness variation does not vary significantly over the height of the battery cell due to the observed mechanisms. However, a slight decrease in the volume change towards the poles of the battery cells due to the higher stiffness can be monitored.
Silicon carbide and an aluminum alloy (SiC/AlSi12) composite are obtained during the pressurized casting process of the aluminum alloy into the SiC foam. The foam acts as a high-stiffness skeleton that strengthens the aluminum alloy matrix. The goal of the paper is to describe the behavior of the material, considering its internal structure. The composite’s structure is obtained by using X-ray computing tomography. The thorough computer tomography analysis allows for the high-precision identification of the shape and distribution of the pores in the matrix. The computational model prepared in the framework of the peridynamics method takes into account the pores and their shape. The pores in the structure appeared in the fabrication process. The impact of a steel ball is studied employing the peridynamics method. The sample without any porosity and a porous one were considered during the analyses. It has been found that the porosity of the matrix influences the plastic strain development, but the damage parameter in the skeleton is not affected significantly. The damage advancement in the skeleton during the process is practically identical in both cases. The equivalent plastic strain field is much smoother in a non-porous matrix than in a porous one. The porous matrix has high equivalent plastic strain concentrations, much higher than the non-porous matrix. The shape of the sample is affected by the porosity of the matrix. The sample with a porous matrix tends to fragment, and it shows a tendency towards spallation when in close contact to the surface with the base.