To meet the requirements of high‐power compensating occasion such as electrochemical industries, a multifunctional hybrid active power converter (HAPC) with LC series filter is studied to effectively integrate functions of rectification and power compensation. HAPC can be used as a high‐power pulse width modulation rectifier to supply its dc load, meanwhile, it can also compensate large amount of reactive and harmonic current without increasing the voltage rating of itself. A compound current control method for HAPC is introduced so as to improve the dynamic tracking performance. The current and voltage dual closed‐loop system of HAPC is built in s domain, and the detailed control parameters are designed to tune control performance further. Finally, a set of 800 kVA HAPC system for electrolytic copper‐foil is developed. The results show that the HAPC system can achieve expected operation performance and largely improves power quality of power grid.
Modular multilevel converters (MMCs) have become one of the most attractive topologies for high-voltage and high-power applications. A double-carrier phase disposition pulse width modulation (DCPDPWM) method for MMCs is proposed in this paper. Only double triangular carriers with displacement angle are needed for DCPDPWM, one carrier for the upper arm and the other for the lower arm. Then, the theoretical analysis of DCPDPWM for MMCs is presented by using a double Fourier integral analysis method, and the Fourier series expression of phase voltage, line-to-line voltage and circulating current are deduced. Moreover, the impact of carrier displacement angle between the upper and lower arm on harmonic characteristics is revealed, and further the optimum displacement angles are specified for the circulating current harmonics cancellation scheme and output voltage harmonics minimization scheme. Finally, the proposed method and theoretical analysis are verified by simulation and experimental results.
The hybrid modular multilevel converter (MMC) consisting of half-bridge submodules (HBSMs) and full-bridge submodules (FBSMs) is a promising solution for overhead lines high-voltage direct current systems (HVDC) due to the advantages of direct current short circuit fault ride-through (DC-FRT) capability. This paper proposes an improved phase-disposition pulse width modulation (PDPWM) method for the hybrid modular multilevel converter. The number of carriers can be reduced from 3N (N is the number of submodules in each arm) to 6. The theoretical harmonic analysis of the improved PDPWM method for hybrid MMC is performed by using double Fourier integral analysis. The influence of three carrier displacement angles between HBSMs and FBSMs in the upper and lower arms on harmonic characteristics is investigated. The output voltage harmonics minimization PDPWM scheme and circulating current harmonics cancellation PDPWM scheme can be achieved by selecting the optimum carrier displacement angles, respectively. The proposed method for hybrid MMC is verified by the simulation and experimental results.
This paper proposed an improved carrier phase disposition modulation strategy for modular multilevel converter(MMC), namely a single-carrier modulation strategy. It uses a single triangular carrier to achieve multilevel modulation. It has advantages of both good harmonic characteristics for carrier phase disposition modulation and switch balanced distribution of carrier phase shifted modulation. In order to solve the problem of submodule capacitor voltage imbalance of the MMC, this paper presents a switching allocation strategy according to submodule capacitor voltage sorting. The proposed modulation strategy and switch balanced distribution strategy was verified by the PSIM simulation.
12 October 2018 in Journal of Modern Power Systems and Clean Energy
Modular multilevel converters (MMCs) operate in the low modulation index region in many applications. However, when utilized at the low modulation index region, large harmonics appear in the output voltage, which degrade the performance of the MMC. To improve the harmonic characteristic in the low modulation index, the carrier dynamic overlapping switching frequency optimal pulse width modulation (CDOSFOPWM) method is proposed for the MMC here. The whole modulation index region is divided into three regions: high modulation index region, middle modulation index region, and low modulation index region. The carrier amplitude, carrier overlap ratio, and frequency of triangular carriers are chosen dynamically according to the modulation index region of the modulation signals, to achieve the optimal harmonic characteristic in the whole modulation index region and maintain the switching loss. The number of on-state submodules (SMs) can be calculated by CDOSFOPWM, and the selection of SMs is performed by a reducing switching frequency voltage balancing algorithm. Finally, the proposed method is verified by simulation and experimental results.