Excitation–emission-spectral unmixing-based fluorescence resonance energy transfer (ExEm-spFRET) microscopy exhibits excellent robustness in living cells. We here develop an automatic ExEm-spFRET microscope with 3.04 s of time resolution for a quantitative FRET imaging. The user-friendly interface software has been designed to operate in two modes: administrator and user. Automatic background recognition, subtraction, and cell segmentation were integrated into the software, which enables FRET calibration or measurement in a one-click operation manner. In administrator mode, both correction factors and spectral fingerprints are only calibrated periodically for a stable system. In user mode, quantitative ExEm-spFRET imaging is directly implemented for FRET samples. We implemented quantitative ExEm-spFRET imaging for living cells expressing different tandem constructs (C80Y, C40Y, C10Y, and C4Y, respectively) and obtained consistent results for at least 3 months, demonstrating the stability of our microscope. Next, we investigated Bcl-xL-Bad interaction by using ExEm-spFRET imaging and FRET two-hybrid assay and found that the Bcl-xL-Bad complexes exist mainly in Bad-Bcl-xL trimers in healthy cells and Bad-Bcl-xL2 trimers in apoptotic cells. We also performed time-lapse FRET imaging on our system for living cells expressing Yellow Cameleon 3.6 (YC3.6) to monitor ionomycin-induced rapid extracellular Ca2+ influx with a time interval of 5 s for total 250 s.
Mo:BiVO4 nanoparticles were employed as an optical modulator in a Q-switched all-solid-state Tm:YAP laser for the first time. The nonlinear optical parameters of Mo:BiVO4 nanoparticles in the 2-μm region were characterized by measuring nonlinear transmission. Saturation intensity was 718 MW/cm2, and the modulation depth was 12.3%. A stable pulse sequence was acquired with a 70.08 kHz maximum repetition rate and an 821 ns pulse width. The maximum output average power was 153 mW, corresponding to 2.18 μJ single pulse energy and 2.67 W peak power. Although the response wavelength of Mo:BiVO4 is in visible light region, our experimental results demonstrates that a saturable absorption effect for wavelengths much longer than visible light (2 μm wavelength) is still possible due to sub-bandgap absorption. Therefore, we experimentally proved that Mo:BiVO4 nanoparticles are a great candidate for use as an optical modulator of a 2-μm pulsed laser.
We present a high-power, wavelength-tunable picosecond Yb3+: CaGdAlO4 (Yb:CALGO) laser based on MgO-doped lithium niobate (MgO:LN) nonlinear mirror mode locking. The output wavelength in the continuous wave (CW) regime is tunable over a 45 nm broad range. Mode locking with a MgO:LN nonlinear mirror, the picosecond laser is tunable over 23 nm from 1039 to 1062 nm. The maximum output power of the mode-locked laser reaches 1.46 W, and the slope efficiency is 18.6%. The output pulse duration at 1049 nm is 8 ps. The laser repetition rate and bandwidth are 115.5 MHz and 1.7 nm, respectively.
A stable, passively Q-switched Yb:CaGdAlO4 laser based on Mo:BiVO4 saturable absorber was demonstrated. Close observations of the structure and morphology of the nanoparticles by using transmission electron microscope, Raman spectrum and linear absorption were measured. The nonlinear transmission of Mo:BiVO4 was characterized by a 30 ps laser with a central wavelength of 1064 nm and a repetition rate of 10 Hz. The experimental maximum output power of the pulsed laser was 510 mW with a repetition rate of 87 kHz and pulse width of 3.18 μs, corresponding to a peak power of 1.84 W and a single pulse energy of 5.8 μJ. The experimental results indicate that Mo:BiVO4-SA is a great candidate for passively Q-switched lasers in the near infrared region.