Electronic skins (e-skins) are devices that can respond to mechanical stimuli and enable robots to perceive their surroundings. A great challenge for existing e-skins is that they may easily fail under extreme mechanical conditions due to their multilayered architecture with mechanical mismatch and weak adhesion between the interlayers. Here we report a flexible pressure sensor with tough interfaces enabled by two strategies: quasi-homogeneous composition that ensures mechanical match of interlayers, and interlinked microconed interface that results in a high interfacial toughness of 390 J·m⁻². The tough interface endows the sensor with exceptional signal stability determined by performing 100,000 cycles of rubbing, and fixing the sensor on a car tread and driving 2.6 km on an asphalt road. The topological interlinks can be further extended to soft robot-sensor integration, enabling a seamless interface between the sensor and robot for highly stable sensing performance during manipulation tasks under complicated mechanical conditions.

Stretchable ionotronics have drawn increasing attention during the past decade, enabling myriad applications in engineering and biomedicine. However, existing ionotronic sensors suffer from limited sensing capabilities due to simple device structures and poor stability due to the leakage of ingredients. In this study, we rationally design and fabricate a plethora of architected leakage-free ionotronic sensors with multi-mode sensing capabilities, using DLP-based 3D printing and a polyelectrolyte elastomer. We synthesize a photo-polymerizable ionic monomer for the polyelectrolyte elastomer, which is stretchable, transparent, ionically conductive, thermally stable, and leakage-resistant. The printed sensors possess robust interfaces and extraordinary long-term stability. The multi-material 3D printing allows high flexibility in structural design, enabling the sensing of tension, compression, shear, and torsion, with on-demand tailorable sensitivities through elaborate programming of device architectures. Furthermore, we fabricate integrated ionotronic sensors that can perceive different mechanical stimuli simultaneously without mutual signal interferences. We demonstrate a sensing kit consisting of four shear sensors and one compressive sensor, and connect it to a remote-control system that is programmed to wirelessly control the flight of a drone. Multi-material 3D printing of leakage-free polyelectrolyte elastomers paves new avenues for manufacturing stretchable ionotronics by resolving the deficiencies of stability and functionalities simultaneously.