Undoped and Al-doped ZnO films were synthesized by atomic layer deposition at 150°C and then annealed at 350°C in different atmospheres. Effects of doping and annealing on the film growth mode and properties were investigated. The undoped film has strong UV emission and weak Zn interstitial emission. Annealing introduces O vacancies, decreases Zn interstitials, and results in weakening and blue-shifting of the UV emission which is sensitive to annealing atmosphere. Al doping induces the film growing with its c-axis parallel to the substrate surface. It also introduces non-radiative centers and weakens the UV emission. Al doping widens the film bandgap, which has a quadratic dependence on Al content. Al doping decreases the film resistivity to 5.3 × 10−3 Ω · cm. Annealing has little effect on photoluminescence of the doped films, but it degrades undoped and doped ZnO film conductivity dramatically; and the degradation depends on the annealing ambient.
We used surface-enhanced Raman scattering (SERS) for the quantitative and sensitive detection of chloramphenicol (CAP). Using 30 nm colloidal Au nanoparticles (NPs), a low detection limit for CAP of 10−8 M was obtained. The characteristic Raman peak of CAP centered at 1344 cm−1 was used for the rapid quantitative detection of CAP in three different types of CAP eye drops, and the accuracy of the measurement result was verified by high-performance liquid chromatography (HPLC). The experimental results reveal that the SERS technique based on colloidal Au NPs is accurate and sensitive, and can be used for the rapid detection of various antibiotics.
Oxygen-rich pyromellitic acidic anions (PMA4−) have been intercalated into MgAl-layered double hydroxides to fabricate the MgAl–PMA–LDH (abbr. PMA–LDH) composite exhibiting excellent adsorption performance toward uranium (U(VI)). Benefiting from the large number of functional groups of –COO−, the PMA–LDH displays an extremely large maximum U adsorption capacity (qUm) of 352 mg g−1 and an ultra-fast sorption rate, reaching uptakes of ∼97% within 30 min and >99% in 1 h at the initial U concentration (CU0) of 113 ppm. Over a very wide pH range of 5–11, high U removals (>93%) are achieved at CU0 = 105 ppm. Moreover, in the presence of highly concentrated competitive ions, ultra-high selectivity of UO22+ is observed, giving a very large distribution coefficient (Kd) of ∼106 mL g−1. Moreover, the PMA–LDH exhibits effective capture of UO22+ in contaminated simulated seawater, showing high uptakes of >93% at CU0 ∼ 10 ppm and >98% at CU0 ∼ 100 ppm. The dispersion effect of LDH layers may contribute to the increase of U adsorption capacity, and the confinement effect of LDH is conducive to the improvement of sorption selectivity toward U. The exploration of the interaction mechanism of UO22+ with PMA4− confined within the LDH gallery offers an important basis for the fabrication of new kinds of organic/inorganic hybrid materials. The PMA–LDH is a highly effective adsorbent which can be applied to uranium extraction from seawater and uranium disposal in nuclear wastewater.
Through the swelling/restoration reaction, acetamidoxime (ACAO) and the hydrolysates of carboxylic anions are co-intercalated into MgAl-LDH interlayers to generate a new material ACAO-AC-LDH. The as-formed ACAO-AC-LDH displays outstanding adsorption performance for uranium (U(VI)) both at high (ppm) and low (ppb) concentrations. The enormous maximum U sorption capacity (qUm) of 339 mg g−1, exceptionally rapid uptake (k2 = 3.06 g mg−1 min−1), and ultrahigh % removals (>90% at CU0 = 1–100 ppm) are among the best reported for U sorbents. For natural seawater with a trace amount of U (∼3.65 ppb) but highly concentrated concomitant cations of Ca2+ (∼400 ppm), Mg2+ (∼1300 ppm), K+ (∼500 ppm) and Na+ (∼11 000 ppm), the ACAO-AC-LDH can trap ≥99.99% U (reduced to ≤0.001 ppb), exhibiting extremely high selectivity (KUd ∼ 106 mL g−1) and capture ability for U. All these demonstrate that ACAO-AC-LDH is a first-class uranium sorbent, which is suitable for removing U from nuclear waste and extracting U from seawater.
Water-soluble nanoclusters, which are facilely enrichable without changes in the original properties, are highly demanded in many disciplines. In this contribution, a new class of gold nanoclusters (AuNCs) was synthesized using glutathione disulfide (GSSG) as a reducing and capping agent under intermittent heating mode. The as-prepared GSSG–AuNCs had a higher quantum yield (4.1%) compared to the conventional glutathione-protected AuNCs (1.8%). Moreover, by simply introducing the GSSG–AuNC solution to acetonitrile at a volume ratio of 1:7, a new bottom phase was formed, in which GSSG–AuNCs could be 400-fold enriched without changes in properties, with a percentage recovery higher than 99%. The enrichment approach did not need additional instruments and was potentially suitable for large-scale enrichment of nanoclusters. Further, density functional theory calculations indicated that the hydrogen bonding between GSSG and acetonitrile plays a key role for the bottom phase formation. Our work suggests that the highly emissive GSSG–AuNCs possess great potential not only in fluorescent measurements but also in other scenarios in which high-concentration AuNCs may be needed, such as catalysis, drug delivery, and electronic and optical industries.
19 August 2022 in Frontiers of Chemical Science and Engineering