Laser spectroscopy outperforms electrochemical and semiconductor gas sensors in selectivity and environmental survivability. However, the performance of the state-of-the-art laser sensors is still insufficient for many high precision applications. Here, we report mode-phase-difference photothermal spectroscopy with a dual-mode anti-resonant hollow-core optical fiber and demonstrate all-fiber gas (acetylene) detection down to ppt (parts-per-trillion) and <1% instability over a period of 3 hours. An anti-resonant hollow-core fiber could be designed to transmit light signals over a broad wavelength range from visible to infrared, covering molecular absorption lines of many important gases. This would enable multi-component gas detection with a single sensing element and pave the way for ultra-precision gas sensing for medical, environmental and industrial applications.
Optical fiber sensor emerges as a highly promising technology for trace gas detection due to their high sensitivity, remote capability, and immunity to electromagnetic interference. However, the state‐or‐the‐art fiber‐optic gas sensors typically use lengthy optical fibers as gas absorption cells or coatings with functional materials to achieve more sensitive gas detection, which poses challenges such as slow response and/or poor selectivity, as well as limitations on their use in confined spaces. Here, an ultraminiature optical fiber‐tip photothermal gas sensor via direct 3D micro‐printing of a Fabry‐Pérot cavity on the end face of a standard single‐mode optical fiber is reported. It enables not only direct interaction between light and gas molecules at the fiber output but also remote interrogation through an interferometric read‐out scheme. With a low‐finesse microcavity of 66 µm in length, a noise equivalent concentration of 160 parts‐per‐billion acetylene gas is demonstrated with an ultra‐fast response time of 0.5 s. Such a small high‐performance photothermal gas sensor offers an approach to remotely detecting trace gases for a myriad of applications ranging from in‐reactor monitoring to medical diagnosis.
We demonstrate sensitive gas detection with mode-phase-difference photothermal spectroscopy assisted by a long period grating (LPG) inscribed on a dual-mode negative-curvature hollow-core fiber (NC-HCF). The LPG is inscribed using a pulsed laser, which enables pump propagation in the fundamental mode to achieve maximum photothermal phase modulation while exciting both the and modes at the probe wavelength to form a dual-mode interferometer for detection of the phase difference. With a 1533 nm pump and a 1620 nm probe, a noise equivalent concentration of ppb acetylene is achieved with an 85-cm-long NC-HCF gas cell and 1 s lock-in time constant.
We demonstrate a high sensitivity all-fiber spectroscopic methane sensor based on photothermal interferometry. With a 2.4-m-long anti-resonant hollow-core fiber, a 1654 nm distributed feedback laser, and a Raman fiber amplifier, a noise-equivalent concentration of methane is achieved at the room temperature and pressure of . The effects of temperature on the photothermal phase modulation as well as the stability of the interferometer are studied. By introducing a temperature-dependent compensation factor and stabilizing the interferometer at quadrature, signal instability of is demonstrated for temperature variation from 296 to 373 K.
29 November 2023 in Journal of Lightwave Technology
We report a miniature optical fiber photothermal (PT) gas sensor with high sensitivity, fast response and large dynamic range. The sensing region is an air gap formed between the cleaved ends of two single mode fibers (SMFs). Theoretical formulations of photothermal phase modulation and interferometric phase detection are presented. Numerical simulation and experimental investigation are carried out to optimize the system parameters to maximize the photothermal signal. A gas sensor with an air gap of 130 μm demonstrates a noise equivalent concentration of 45 parts per billion and dynamic range of 2 × 10 7 for acetylene detection, with a response time of 0.9 s. The sensor is simple to construct and may be used for real-time gas detection in a confined space.