The study of commercial low-density polyethylenes (LDPEs) has always focused on the effects of the molecular architecture of the polymer on its shear and extensional rheological properties due to their direct influence on manufacturability. However, the complex morphology of industrial-grade LDPEs also affects the crystallization kinetics and dynamic mechanical properties of the polymers, which are key to the processibility and applications. Therefore, a comprehensive investigation was conducted into the areas of crystallization kinetics, crystallinity, dynamic mechanical, and linear and non-linear shear rheological properties of two industrial-grade LDPEs to build a cohesive insight into the influence of morphology on these material properties. We further analyzed the steady-state and transient shear viscosity data obtained from the two LDPEs in comparison with constitutive model predictions using the hierarchical multi-mode molecular stress function (HMMSF) and found excellent agreement within experimental accuracy between predictions by the HMMSF model and shear stress as well as normal stress data of the LDPEs investigated.
Rheological equations of state are of great importance for characterization of polymer melts and for simulation of polymer processing. This concise review considers tube model based constitutive equations developed in the last 40 years since the original publication of Doi and Edwards in 1978. The emphasis is on the concepts, assumptions, and material parameters introduced to model nonlinear viscoelasticity of polydisperse linear and long-chain branched polymer melts. Linear viscoelasticity is assumed to be known, either from linear-viscoelastic modeling or by experimental characterization. The scope is limited to constitutive equations which are based on the linear-viscoelastic relaxation modulus and can be expressed in terms of integral, differential, or integro-differential equations. Multimode models based on the concept of preaveraged stretch require a large number of nonlinear model parameters. Relaxing the assumption of a constant tube diameter, the number of nonlinear model parameters can be drastically reduced to 2 or 3, independent of the number of Maxwell modes needed to represent the linear viscoelasticity.
A novel criterion for brittle fracture of entangled polymer liquids is presented: Crack initiation follows from rupture of primary C–C bonds, when the strain energy of an entanglement segment reaches the energy of the covalent bond. Thermal fluctuations lead to a short-time concentration of the strain energy on one C–C bond of the entanglement segment, and the chain ruptures. This limits the maximum achievable stretch of entanglement segments to a critical stretch of fc≤6. Recent experimental data of Huang et al. [Phys. Rev. Lett. 117, 087801 (2016)]] and Huang and Hassager [Soft Matter 13, 3470–3474 (2017)] on fracture of solutions of nearly monodisperse polystyrenes dissolved in oligomeric styrene and of a well characterized polydisperse polystyrene melt, are in general agreement with this fracture criterion. For quantitative agreement, finite extensibility effects have to be considered.