Arsenite (As(III)) contamination in drinking water has become a worldwide problem in recent years, which leads to development of various As(III) remediation approaches. In this study, two biomass-based nanostructured materials, microscale dialdehyde cellulose–cysteine (MDAC–cys) and nanoscale dialdehyde cellulose–cysteine (NDAC–cys) fibers, have been prepared from wood pulp. Their As(III) removal efficiencies and mechanism were determined by combined adsorption, atomic fluorescence spectrometry, microscopy (scanning electron microscopy, transmission electron microscopy, and atomic force microscopy), and spectroscopy (Fourier transform infrared, 13C CPMAS NMR) methods. The adsorption results of these materials could be well described by the Freundlich isotherm model, where the maximum adsorption capacities estimated by the Langmuir isotherm model were 344.82 mg/g for MDAC–cys and 357.14 mg/g for NDAC–cys, respectively. Both MDAC–cys and NDAC–cys materials were further characterized by X-ray diffraction and thermogravimetric analysis, where the results indicated that the thiol groups (the S content in MDAC–cys was 12.70 and NDAC–cys was 17.15%) on cysteine were primarily responsible for the adsorption process. The nanostructured MDAC–cys system appeared to be more suitable for practical applications because of its high cost-effectiveness.
Thallium(I) (Tl(I)) pollution has become a pressing environmental issue due to its harmful effect on human health and aquatic life. Effective technology to remove Tl(I) ions from drinking water can offer immediate societal benefits especially in the developing countries. In this study, a bio-adsorbent system based on nitro-oxidized nanocellulose (NOCNF) extracted from sorghum stalks was shown to be a highly effective Tl(I) removal medium. The nitro-oxidation process (NOP) is an energy-efficient, zero-waste approach that can extract nanocellulose from any lignocellulosic feedstock, where the effluent can be neutralized directly into a fertilizer without the need for post-treatment. The demonstrated NOCNF adsorbent exhibited high Tl(I) removal efficiency (>90% at concentration < 500 ppm) and high maximum removal capacity (Qm = 1898 mg/g using the Langmuir model). The Tl(I) adsorption mechanism by NOCNF was investigated by thorough characterization of NOCNF-Tl floc samples using spectroscopic (FTIR), diffraction (WAXD), microscopic (SEM, TEM, and AFM) and zeta-potential techniques. The results indicate that adsorption occurs mainly due to electrostatic attraction between cationic Tl(I) ions and anionic carboxylate groups on NOCNF, where the adsorbed Tl(I) sites become nuclei for the growth of thallium oxide nanocrystals at high Tl(I) concentrations. The mineralization process enhances the Tl(I) removal efficiency, and the mechanism is consistent with the isotherm data analysis using the Freundlich model.
Mercury contamination in drinking water is a worldwide problem due to its severely harming effects on the human body. A nanostructured natural bioadsorbent, carboxycellulose nanofiber extracted from raw moringa plant using the nitro-oxidation method (termed NOCNF), capable of effectively remediating this problem has been demonstrated. Nitro-oxidation is a simple approach that can extract carboxylated nanocellulose directly from raw biomass. In this study, the produced NOCNF contained a large density of carboxylate groups on the cellulose surface (0.97 mmol/g), capable of removing Hg2+ ions by simultaneous electrostatic-interactions and mineralization processes. Using the Langmuir analysis, the adsorption results indicated that the highest Hg2+ removal capacity of this NOCNF was 257.07 mg/g, which is higher than most of the reported values. The interactions between Hg2+ and NOCNF were further characterized by Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy/energy dispersive spectroscopy (SEM/EDS), transmission electron microscopy (TEM) with electron diffraction and wide-angle X-ray diffraction (WAXD) methods, suggesting the existence of two distinct removal mechanisms: predominant adsorption at low Hg2+concentrations (< 250 ppm) and predominant mineralization at high Hg2+ concentrations (> 1000 ppm). The applications of NOCNF were illustrated in both suspension form, as an adsorbent/coagulant, and dry powder form using filtration column. The results indicated that NOCNF in suspension exhibited a higher maximum removal efficiency of 81.6 % as compared to the dry state of 74.3 %. This work demonstrated the feasibility of extracting nanostructured adsorbents from biomass feedstocks to tackle the Hg2+ contamination problem in drinking water.